Your cart is empty.
Your cart is empty. Features
【PCB】Optocoupler isolation board is manufactured with high quality PCB material, featuring reliability and miniaturization, easy to maintain and replace.
【OUTPUTS】Optical isolator module can realize the outputs as high level outputs or pull-down outputs through jumper caps.
【INDEPENDENT CONTROL】The four 817 channels on the photoelectric isolated module board are independent, allowing simultaneous control of different voltages.
【CONTROLLED TERMINAL】Voltage converter adapter module can realize 3.3V or 5V control interface, after the control terminal is turned on, the controlled terminal will also be turned on at the same time.
【APPLICABLE】Optocoupler optoisolator has strong anti-interference ability, it can drive high power transistors, MOS tubes and other occasions that require high voltage drive, and it can also directly drive low power 24V relay work.
Specification
ItemType: Optocoupler Isolation Board
Material: PCB
Driver Semaphore Voltage: 3.6-24V
Output Voltage Range: 3.6-30V (output current depends on the specific situation, but the maximum power is not exceed 10MA, the total power is constant, the voltage and current are inversely proportional)
Package List
1 x Optocoupler Isolation Board
NoteIf it is a pulse semaphore, please note that the limit of 817 is below 4KHZ, please do not use this module for control semaphore greater than 4KHZ, which will not work properly.
David Cook
Reviewed in the United States on July 7, 2024
Nice quality board, but be advised that the channels are not truly isolated from each other. The INPUT grounds are tied together on the board. This can lead to interesting results (e.g. smoke) when the board is used to interface FROM various sensors to a microcontroller when the sources do not have a common ground. Bad design for a component that is supposed to provide isolation. Not a problem IF the board is used for multiple OUTPUTS from a single microcontroller.
Recommended Products
