Your cart is empty.
Your cart is empty.Product Description
The M.2 Heatsink is a new combination of copper and graphene, they are perfect solution of heat sink, comes with a high quality thermal pad.
2mm heatsink is usually for laptop, 4mm is usually for desktop computer, please purchase as needed based on actual situation
Nobody
Reviewed in Canada on July 3, 2024
Of the three elastics supplied, two broke after barely a month's use. Not worth it IMHO.
Eugene Powers
Reviewed in the United States on May 24, 2024
Everything is good except the rubber rings that broke very quickly due to heat probably. But the silicon pads kept the heatsinks on. One of my SSDs run as low as 34 degrees. That is very low.
Cyberwip
Reviewed in Canada on May 11, 2024
I bought one to place on an NVMe stick for a Raspberry Pi, thinking that this should be enough (or much better than nothing).While it may absorb heat, it doees little to dissipate it and even the narrow, shallow cutouts on the top work very poorly for convection cooling (even with a fan).There should be wider gaps, narrower fins, and more rows.This is just a chunk of bolt-on metal that does nothing but get hot, and cool poorly.Cheap ROUND ruber bands all broke only days after installation.Thermal tape is low quality - thinner is better.After trying it I wish I could think of a use for it, and maybe heatsink is a good description, but 'radiating cooler' is not.
Carl H.
Reviewed in Canada on February 9, 2024
It took some googling to figure out what the o-rings were for.
RAMBO
Reviewed in the United States on December 8, 2024
Feels premium in hand, and seems very capable to dissipate the heat
Greg
Reviewed in the United States on December 26, 2024
I have a few of these and they work well and are not to difficult to install
NKurth
Reviewed in the United States on December 15, 2024
Works but the black bands tend to break.
J.Sprat
Reviewed in the United States on November 25, 2024
I have a BMax mini pc with almost no room for a M.2 2280 heatsink. Being so compact, there is almost no airflow despite all the fans being in perfect working order. My CPU was running on average at 78°C, with highs at about 88°C. My WD Blue M.2 SATA 2TB drive is right next to the CPU, and was running on average at 72°C, with highs at about 86°C. After installing this little heatsink, the drive runs on average at 56°C, while the CPU stays unchanged of course. This is probably the most effective slim heatsink I have ever tried. The little rubber rings are a bit difficult to handle, but they give you an alternative with the fabric straps, and those work well. Though, you get better contact and heat transfer with the rubber rings. Overall, a good design for difficult form factors.
Daniel Stone
Reviewed in Canada on October 8, 2024
ASUS strix laptop go BRRR now, I added these heatsinks and an additional SAS to laptop and they preform well with the assistance of these heatsinks!
kappy
Reviewed in the United States on October 22, 2024
This heat sink is easy to install and it works.
Butterburns
Reviewed in the United States on January 24, 2024
This was a solid buy, it was easy to install …except for the small rubber bands. They’re so tough to stretch! As you can see, I used some angled pliers to get all three of them over the drive and heatsink. I accidentally scraped some of the coating off in the process, but you can see the heatsink is indeed copper. That’s a good thing! I’ll likely buy this heatsink kit again in the future. Good product.
Samuel prime
Reviewed in Canada on September 23, 2023
This thing dropped my temps by probably 3-5c, which might not sound like a lot, but when running a drive that runs hot, it's super helpful. Better than paying 50-60 more for a drive that has a heatsink attached.
Jeremy Denslinger
Reviewed in the United States on October 10, 2023
I bought this to add to a rather hot chip on a Macintosh Performa 630CD DOS Compatible.The low profile is perfect for fitting under the DOS card, without shorting out on any of the solder joints. The blue insulative tape is there, just in case - but there's a good .5-.75mm of space between the tape and the bottom of the DOS card! Oh, and it drains the heat away very nicely, assisted with a noctua fan I shoe-horned into place, to blow across this heatsink, as well as the 486DX/2 on the DOS card. So much better!Just because a hunk of metal is designed for one use don't mean you can't use it for something else :D
Recommended Products
$27.98
$ 13 .99 $13.99