Your cart is empty.
Your cart is empty.Verify the part fits before purchasing Specs:Description: Complete Tune Up KitNotes: For 4 cylinder models w/front mount distributors.Replaces OEM Numbers:Ford/New Holland: 309786Compatible With / Replacement For:Ford/New Holland 2N, 8N, 9N
wol5797
Reviewed in Canada on January 3, 2025
Good delivery with dragonfly
Lonnie B
Reviewed in the United States on January 26, 2025
Great deal with installation instructions that are clear.
Brian H.
Reviewed in the United States on September 2, 2024
Works but definitely cheap. Spend a little more and get a better kit.
Mosteller
Reviewed in the United States on August 2, 2024
Price was better than Ebay and it worked. the quality was not the highest but it did fit and work. My old N2 Ford tractor stuff was worn out so I replaced them with this and it is running now so I am satisfied.
Customer
Reviewed in the United States on May 13, 2024
I purchased two of these tune up kits. I could not get either point sets to work on two different tractors. After measuring all the components, I found that the contact points of the non-stationary side are too short. I could not get the minimum adjustment I needed so I had to use the old point set. As you can see in the picture the points on the left are the old point and the new points are on the right. The reason for purchasing the two set was to replace the parts that ware out. Needless to say, they are most important item in the kit. Not happy at all!!!!!
larry edwards
Reviewed in the United States on March 16, 2024
Used this kit on a 1944 2N Ford tractor.Parts worked but some such as the points were badly constructed and couldn't be used.Otherwise the kit was ok.
Customer
Reviewed in the United States on December 8, 2024
Quality parts. nice kit
Bruce W. Sancomb CHt.
Reviewed in the United States on December 5, 2024
Perfect fit
STEVEUNDERWOOD
Reviewed in the United States on March 26, 2023
Packaged extremely well, quality fine except for the wire. Cheap very thin copper ends that have to be filed round in order to fit in the distributor, then will get stuck and separate when removing wire!Loose fitting boots that might vibrate loose.Distributor cap and rotor are excellent, identical to OEM.
CarolJens
Reviewed in Canada on January 16, 2023
Had to file holes to make it fit and Points made of plastic and melted after a few minutes of running tractor. Waste of money
Len
Reviewed in Canada on August 18, 2022
Wires, condenser, plugs, rotor and distributor all fit and worked well. Some the old wires were bad and replaced. The points are plastic and melted due to the old coil shorting. Once a new coil was put in... the tractor started and ran like new again. A tune up kit was long in need.
Tractor Boy
Reviewed in Canada on June 25, 2022
Parts all seemed to work although the points wouldn’t close and had to bend the bracket a bit. Someone complained about the spark plugs sent. Nothing wrong with them and work perfectly.
DAT
Reviewed in Canada on December 13, 2021
My items arrived on time and were packaged well. I've installed the plugs, wires, distributor cap and rotor, but will wait till spring to install the points and condenser. It all works well and the tractor is definitely running better. Cutting and assembling the plug wires was easy. The price was less than any of the parts suppliers around my area.
Recommended Products
