Your cart is empty.
Your cart is empty.4.6 out of 5 stars
- #22,760 in Home & Kitchen (See Top 100 in Home & Kitchen)
- #56 in Accessories (Home & Kitchen)
Vogt Remodeling
Reviewed in the United States on February 25, 2025
These worked perfectly for the new mini split system I installed on one of my rental homes. The holes lined right up perfectly the installation of them were a cakewalk and try hold a great amount of weight as well ! They give great support to the unit that they are supporting! Will most definitely be purchasing more for any other units i purchase for my other houses
Scott A Seals
Reviewed in the United States on January 5, 2025
I tried to install a mini-split with oem hardware. I was never convinced that it wasn't going to fall off the wall. So I ordered this kit. It is easy to mount. I like that I can make sure to hit both studs while being able to adjust the arms to fit my unit.
Rick Hamner
Reviewed in the United States on January 26, 2025
These brackets works great on my mini-split. These were installed several months ago and they are still holding up.
Justin Wilson
Reviewed in the United States on January 24, 2025
These work as designed. Multiple mounting options. Much cheaper than going to the local big box store and buying them.
Ronald J. Fisher
Reviewed in the United States on January 19, 2025
Well made
Allen V Petten
Reviewed in Canada on August 15, 2024
Used them to install 12000 BTU unit on my outside wall. Very easy,
Estefania Rojas
Reviewed in Mexico on May 11, 2024
Cumple su funcion
gary baughn
Reviewed in the United States on December 15, 2024
I did end up changing to a different style of wall anchor due to installing on a brick wall. But all in all a decent product. Had to mount all the way to the fron of hanger to get rear clearance. But worked out fine. Been holding a 24,000 btu split air up for six months now without issue.
Trackster Geezer
Reviewed in the United States on November 14, 2024
The brackets are definitely strong enough and they have a pretty durable finish. The mounting bolts are a bit overkill if you're mounting to a wood sided wall. I sealed mine out for a little shorter stainless steel lag bolts. The bolts supplied for mounting the compressor are too short to allow for lock washers so I swapped them for some longer stainless bolts as well. Still a good investment.
Enrique lino Cantú rodriguez
Reviewed in Mexico on July 25, 2023
Resistente
Sven Enterlein
Reviewed in the United States on July 22, 2020
I didn't want to put my mini split on the ground to reduce water and dirt splashing on and into the unit during rain so I opted for a wall mount instead. This mount was easy to install and seems very sturdy. I took one star off because I had to completely remove the rubber guard on the vertical part of the brackets to get it close to being level. Instead, I put some very thin flashing tape behind them to prevent metal-on-stone scraping. And yes, I made sure it's not the wall that's out of plumb ;)
W. MacAskill
Reviewed in Canada on May 23, 2019
The brackets were used for a ductless mini-split heat pump. They installed quickly and are working well.
Mossy
Reviewed in Canada on February 12, 2019
As a professional installer, I could not use these stands. They would only provide a few inches of clearance behind the units and this would negatively affect performance even with small units. They are unusable unless you ignore the required clearance.
Recommended Products