Your cart is empty.
Your cart is empty.Laminate Trimmer has a sleek design allowing you close control when trimming away laminate, edge banding and veneer.
shehab saeed
Reviewed in the United Arab Emirates on August 5, 2024
all good
John
Reviewed in the United States on August 29, 2024
I am very happy with this, but it's a Milescraft tool, that's what they do 😉
AH
Reviewed in the United States on March 10, 2024
this is junk. It broke right away. The razor blade is super flimsy and cheap.
xxx
Reviewed in Germany on November 30, 2024
handlicher und und sehr praktischer Helfer in der Holzwerkstatt
JeffA
Reviewed in Australia on November 18, 2024
Good value for money product. Works well trimming the laminate edges.
JoseS
Reviewed in the United States on April 14, 2024
Not only does it not cut, it breaks apart trying to use it.Waste of time and money… luckily it did’t ruin the material.Stay away…
SERGIOH
Reviewed in Mexico on April 1, 2024
Es buen recorta cantos, no lo corta exactamente al ras pero le pasas una lija suavemente y queda buen, se puede manipular muy bien y cómodo.
Customer
Reviewed in the United Kingdom on August 2, 2022
As far as i know it works
K. MAC
Reviewed in the United States on July 19, 2022
Simply does not work, with multiple tries, different edging material. Left splinters or did not trim the edging at all. Easy to use but needs an inordinate amount of pressure and skill to even trim a small section. All the low cost (reasonable) trimmers of this kind do not work well and not worth the money. I can not recommend any other type. As usual return was a snap. cheers.
Ron C.
Reviewed in the United States on January 18, 2021
I am a typical homeowner and built a small cabinet around my laundry tub in the garage. I bought a laminate product for the countertop and use this cutter to trim the edges. It did a perfect job, but I was slow and methodical in the cuts. I think a person with short patience may have a problem since it does require a focused slow movement to get the perfect cut. I am happy with this purchase.
some guy in Missouri
Reviewed in the United States on August 7, 2020
I definitely recommend practicing before trying it on your finished work. It is easy to have it ride on the edge of the edge banding rather than cutting it flush, and it is possible to bear down to hard (or at an angle) and gouge a little from the wood face. But with a little practice, you can get a good trim that just needs a little finish sanding or filing in a few spots.
Lynn Adams
Reviewed in the United States on August 1, 2019
Tool did cut, but not close enough to the edge to make a satisfactory cut. I ended up using a sharp razor blade by hand, then sanding to achieve a clean edge.
jhud
Reviewed in the United States on November 15, 2019
I hesitated to buy this product because it is inexpensive and some of the reviews were pretty bad. But I was about to begin a project of veneering an entire set of cherry kitchen cabinets, and I figured I didn't have much to lose for the price.I have now used it to complete the project, along with projects using oak veneer and white laminate. I can now say the tool is amazing. It makes edges that are so smooth they hardly need any sanding. You just need to change the razor blade after 8 to 10 cuts or so. It is one of the best inexpensive tools I have ever bought.
Recommended Products
$26.69
$ 12 .99 $12.99