Your cart is empty.
Your cart is empty.NA
Stalin Urdaneta
Reviewed in the United States on September 30, 2024
Agrado
JJ Belac
Reviewed in the United States on September 3, 2024
I have a 1997 S10, in which I needed to install a single DIN Pioneer MVH-S322BT. The kit itself fits fine in the truck, but I needed to do some minor trimming with a Dremel in order to get the radio unit to fit in the install kit. Other than that, instructions were clear and the kit assembled easy enough.
Jason E Adkins
Reviewed in the United States on July 10, 2024
Dial an Apple CarPlay in my older vehicle
Bacha
Reviewed in the United States on January 14, 2024
Used on a 1996 Chevy Blazer. Worked good, no issues
N8SX
Reviewed in the United States on April 12, 2024
While it fits and does the job intended it is a little flimsy
Dee G.
Reviewed in the United States on August 30, 2023
Everything lined up great no trimming went from a double din Factory radio to a single Din after market stereo head used the pocket. Great product.
donny
Reviewed in the United States on November 18, 2023
Great deal and easy installation. Looks great finished installation. Very good deal for the money.
Justin Browne
Reviewed in Canada on August 16, 2020
Good construction. Not much else too it. Fits 95 GMC Jimmy SLE.
Customer
Reviewed in the United States on July 6, 2020
Seems to be built fine for the money. I won't give it a bad rating as it is super simple to put together. However,this product in no way fits a 1994 S10 Blazer without major cutting to the product. Not just a simple trim here and there, but a major chop job. The package does not include the 1994 S10 Blazer in the printed description of the vehicles it will work on. So it would be best for the seller to remove the inclusion of the 1994 S10 Blazer.I ended up rigging my own. I used the original brackets for the Delco head unit. You just have to break off the small tabs that slid into the original unit. Super simple. Went to home depot and purchased two #10 1-1/4" screws, then centered the new Kenwood unit using a couple nuts and washers as spacers. I created a simple backplate to fill in the gaps. "Good enough for rock and roll" as my guitar teacher used to say!!The 1994 Chevy S10 Blazer has a very shallow depth for the head unit to fit in at around 5-1/4". I chose a Kenwood unit with cd with a depth of 6.22". Yep it sticks out a bit, but I did not want to cut the air duct at the back of the space. There are certainly head units without cd that are a shallow 5" deep that would fit just fine. I'm just an old guy with ton of cd's too lazy to record them to a digital format!
JB
Reviewed in Canada on March 12, 2019
Perfect fit to truck. Had to modify a bit to fit radio
Recommended Products
