Your cart is empty.
Your cart is empty.Each gage is marked with size and tolerance ( + or -). Photo shows one of our pin gage sets, but not necessarily this specific set.
KetelOne
Reviewed in the United States on June 2, 2022
The box is far bigger than the one in the picture and broke in transit. Due to this it was returned but the current box is so big it would take up a ton of room in your toolbox. I would look elsewhere.
bowcoastie
Reviewed in the United States on March 5, 2021
Updated ReviewWell, the pins are good from a diameter perspective but many of the pins are slightly bent. This makes them impossible to use to check run-out (TIR) in chucks. They are off by only a few thousandths but it makes a difference. Also, if you are measuring deep holes, the bend will cause the hole to appear smaller than it is.Wish I had spent the money for a brand name set.Original ReviewI did a 10% check on the gage pins (measured 10% of them randomly) and found them to be very accurate and true along the length of the entire pin. I am very impressed for the money. I will be purchasing the next biggest set soon.Also, the case is very nice with all of the numbers being readily readable and the lid closes tight. Thank you for the great gage pin set.
Customer
Reviewed in the United States on June 20, 2019
Used to check and set jetting sizes on carburetor jets. Only needed the smaller size gauges but at the price it was cheaper to get the full set
one bad cat
Reviewed in the United States on May 19, 2016
A massive, high-quality set at a good price. Arrived in pristine shape (no rust or bent gages), in a sturdy box, everything finely ground, polished, and made to tight tolerances. I was a bit hesitant at first, but have no regrets going with this brand.
RR
Reviewed in the United States on December 10, 2016
Not bad for the price point. of the 15 or so I have used, all where within .001-.002 of the listed size.
Flinch
Reviewed in the United States on October 31, 2016
Never buy any carburetor without thinking about doing your own QC. At a minimum, you need to know your baseline numbers before attempting any tuning. I had a cheaper pin set before which had many pins off by .0015", making the set only marginally useful as nearly 10% of the sizes listed weren't actually in the box. Spot checking these with a mic found everything spot on: pins undersized by .0005" [+/- .0001], which allows insertion without an interference fit. Found and fixed an idle air bleed mismatch of .002", along with a severely mismatched idle circuit sizing caused by poor drilling practices that had choked off passage almost 50% - guaranteed to cause a bad lean out at idle. Pins all wrapped with preservative, and should arrive spotless. Glad I bought it.
Thomas D. Hanson
Reviewed in the United States on September 30, 2015
very handy
Jerry E Horton
Reviewed in the United States on February 8, 2013
Very nice set, way too many for my needs but they are well made and do what they are intended to do. Well worth the cost.
Recommended Products
$49.99
$ 23 .99 $23.99
$24.83
$ 10 .99 $10.99