Your cart is empty.
Your cart is empty.Product Description
Chris
Reviewed in the United States on February 2, 2025
a real time saver. now if you could buy just the receiving end to go on other brushes. I mean ones that fit this coupler
PLC
Reviewed in the United States on January 9, 2025
Works Perfectly
JEFF
Reviewed in the United States on January 31, 2025
Really easy to use, super value the money, as always Master products are very good.
richard a. brock
Reviewed in the United States on September 6, 2024
what a great thing to have for an air brush kit.
BBQ
Reviewed in the United States on September 3, 2024
This quick disconnect accessory is a must have for the person who uses more than one airbrush in their shop. Fast and easy disconnects for cleaning or switching of devices.
Randy
Reviewed in the United States on July 30, 2024
I was gonna return this at first since it seemed to be leaking air at the connection to the airbrush. But I discovered it was user error and I was over tightening it. Once I loosened it a tad bit I had no problems with leaks and now everything works great! So to anyone reading this and thinking they are having issues connecting without leaking then I recommend fidgeting the tightness levels or possibly even adding plumbers tape
RONALD DMNKLR SMITH
Reviewed in the United States on November 1, 2018
Ok, so take note that I'm NOT using the QD female end, which attaches to the hose, though I did check them and made certain that they work well (I bought 2 of these, will get another soon, as I have 3 Master brushes). I'm actually using the male fittings on 2 of my brushes, but the female I'm using with them is a Badger one, which I got for my Patriot 105. Now, that being said, so far I've had no issues whatsoever. Granted, I am experienced enough to apply teflon tape to all fittings, and apparently some are not, so take that for what you will. No air leaks, no threading issues, no broken seals, etc. All is well, and they're nice and sturdy also, plus they're sized just right so as to not be cumbersome while attached to the brushes while they're being stored in the cases that they come in.
M. Aquino
Reviewed in the United States on April 21, 2010
I have 5 airbrushes and am constantly switching back and forth between them depending on the project I am working on. I have an Iwata PowerJet with 2 hookups but at times it is still a little inconvenient to stop and unhook the airhose from the airbrush and or compressor, especially if I have a good pace and rhythm going. I looked at the branded quick disconnect locally but they were $10 to $15 a piece!Received these and they hook up nicely all my airbrushes. I have two Iwatas, an Aztek, a Masters and a cheap Chinese knock-off. When I tried to connect a 3rd party hose to the bottom of the coupler I found that I could not get it to screw in more than one turn. That one fit fine direcly into my airbrushes.I tried the hoses that came with my Iwata and Master airbrushes, even the Chinese one and they fit perfectly!. So be sure to take a coupler with you to the store to make sure the hose fits or at least be sure to buy from the same manufacturer of one that fits.At first there was a slight hiss indicating an air leak from the coupler but untwisting and twisting the hose coupler took care of that so the o-ring probably wasn't seated right.Now I can go faster without so many frequent stops to change the airhose. Highly recommended. I wish they only sold the barb that connects to the airbrush separately was well because you only need one coupler per hose and then you can switch freely between them, but for $7 who cares?
Recommended Products