Your cart is empty.
Your cart is empty."PROFESSIONAL INSTALLATION IS REQUIRED" Brand New 5HP Single Phase Magnetic Motor Starter. Complete With Adjustable Overload Relay The Range Is Between 22-34 Amps. Also Comes With Built In Side Mounted Auxiliary Contacts. Normally Open & Normally Closed Type. Starter Comes Complete In A Large Metal NEMA 1 Style Enclosure, In Addition To 4 Punch Outs For Incoming And Outgoing Wires. Manufacturer Has Supplied 4 Rubber Grommets For Wire Protection. Reset Button Located On The Overload. Reset Can Be Set To Manual Or Auto Reset. HP: 5/ Voltage: 208-230vac/ Amps: 34 Amp/ Contactor Phase: Single/ Enclosure: Large Metal NEMA 1 Enclosure/ Dimensions: 11" Tall 6.25" Wide 5.75" Depth/ Overload: Amperage 22-34 Amps. If you currently have a 5 HP air compressor and the contacts on your pressure switch keep burning up, a starter is what is needed to fix the problem. If you are using this starter on an air compressor, you will also need a pressure switch to control the starter. In this application the pressure switch controls the On and Off of the starter according to the pressure setting of the pressure switch. Due to this being an electrical item that can be installed incorrectly there is no warranty on this item after installation.
Mike
Reviewed in the United States on July 24, 2024
Works just fine. Using it to power up a 5hp air compressor with a remote RF switch. One issue I have with it are the knockouts. They are not only a bit oversize, but are a pain in the butt to knock the plugs out of them. Once you finally get them open, the conduit, sealtite, or 2-screw romex clamp fits very loosely. I had to use reducing washers to take up the slack.
James Connell
Reviewed in the United States on February 17, 2024
The start stop buttons don’t work. Had to put a disconnect box before the motor starter.
Howard Lee Losey
Reviewed in the United States on October 3, 2024
Installation was simple. Works very well
Paul S.
Reviewed in the United States on August 12, 2023
works as it should. the control wire diagram is "a little" hard to read, but if you are a electrical guy, you can see how to wire it up pretty easy. I like the adjustable FLA setting! The coil voltage is 230 volt, so be aware.
Tom
Reviewed in the United States on February 3, 2023
The only thing I wish I would have done is bought one with on/off button. Watching a YouTube video helps with installation as the instructions are not very useful.
Recommended Products
