Shopping Cart

Your cart is empty.

Your cart is empty.

LUYED 569 578 211-2 212-2 LED Bulbs 1280 Lumens Extremely Bright 3020 18-EX Chipsets 1.6 inches 41mm LED Bulbs Used for Car Interior Map Dome Lights,Xenon White,Pack of 2

Free shipping on orders over $29.99

$11.99

$ 5 .99 $5.99

In Stock

1.:41mm


2.Color:Xenon White


About this item

  • Super Bright & Low Power: (Set of 2 bulbs,6500K,Xenon White) 578 3020 18-EX Chipsets LED Bulbs,640Lumens&2.9W Per Bulb,Much Brighter Than Original Bulb;Bulb size: 1.6" x 0.5" x 0.3",Working voltage:Dc 9-30v
  • Application: Fits:211-2 212-2 214-2 2112 2122 2142 578 576 560 569,Used for Car Interior Map Lights or Dome Lights or Side Door Courtesy Lights etc,,For most vehicles, Just Plug & Play Replacement LED Bulb
  • Heat Dissipation: Built-in intelligent IC driver and aviation aluminum material for better performance,stable input current protects the circuit,Ensure the secure temperature range and consistent brightness out
  • Attention: The bulb size may vary between the model or trim of your vehicle. Please check your vehicles owners manual or the original bulb to confirm the bulb size before placing an order
  • Service: If you have any questions or meet any issues of the order;please let us know;LUYED bulbs are an ideal alternative to halogen bulbs,Just buy with confidence



Product Description

1

2

Product Dimension

1: 1 Size design, same installation position, plug and play

2-2

Aluminum Lamp Cap

Aviation aluminum lamp cap design, non polarity, long service life

2-3

High Quality Chip

3020 high-quality chips, providing super bright light source output

3
3
5

Faith K.
Reviewed in the United States on February 1, 2025
Great bulbs! Fit perfect in Gen 2 Nissan frontier dome lights. Nice white light and way brighter than stock
Scuba Steve
Reviewed in the United States on January 20, 2025
Easy to install. Bright and fits almost exactly like OEM. The color is a deep blue. It doesn't emit too much heat and looks like it'll last a long time.
Dell Arens
Reviewed in the United States on January 17, 2025
Bright bulbs.
TrineoTech
Reviewed in the United States on August 22, 2024
Was quite impressed with the brightness of these lamps. Although the description is a bit misleading, as the total lumens for the PAIR is 1280, not each. However, 640 lumens is quite bright and lights up the interior of the vehicle very nicely. Can't speak to durability at this point, as have only been using them for a couple weeks. However, very pleased with the item so far.
Ronnelson
Reviewed in Canada on May 12, 2024
Put 1 in my truck cab . Easy to install . Works great .
George
Reviewed in the United States on September 9, 2023
Two "bulbs" came in a fancy box - lol - but the multiple LED array is easy to fit into my dome light spaces - I have a '95 Jimmy and the original lamps ran hot, barely gave out any light and if I left my door ajar, would kill my battery overnight. They were so dim, I wouldn't even realize my interior light was still on if my rear door wasn't securely latched. Now, when I walk away from the vehicle, I KNOW... if the lights are still on inside!These lamps are Low current drain. Between the front and rear interior lights these do a great job lighting up the interior of my vehicle so I can see everything without eye strain. the Low Current draw won't kill my battery either. Nothing "cheaply made" about these. well worth the small premium!
Dan
Reviewed in Canada on September 20, 2023
Title says it all. great bulbs, very very bright and clean white color, great heat dissipation, no flickering. Would purchase again.
Shane
Reviewed in Canada on July 16, 2023
Easy to install (in my car anyway). Made the mistake of looking directly at it when I turned it on. Don't do that. Couldn't see properly for about 3 minutes and 54 seconds. They're really bright, give the car that modern luxury feel even though it's a 2001 Civic that barely runs. Can't complain! And you can aim them which is handy.
Mark S. West
Reviewed in the United States on December 8, 2023
BRIGHT WHITE LIGHT for a 1991 Corolla and 1994 Camry - did the trick! Awesome bright lights that were somewhat tricky to install in two of my older Toyotas, but it was worth the effort. For the 1991 Corolla I had a switch that was finicky so I removed the whole assembly from the roof (2 Philips screws & a 2-wire connector) and cleaned the ball/contact assy with DeoxIT (D-series) electrical contact cleaner. It was MUCH EASIER to install the LED lite with the whole thing removed as there is quite a bit of pressure that needs to be applied to get the new lites in the two spring clip contacts. Then just screw back into place and reinstall the plastic prism lens and was good to go. The 1994 Camry was the same except it was retained by 4 screws and the electrical connector. FYI - the dome light circuit gets its grounds from the screws holding the switch/light assy to the roof bracket, so you can't check for proper operation with the light dangling from the 2-wire electrical connector, by the way.
Kay O.
Reviewed in the United States on January 31, 2023
I loved the power of the sun in my little car. You can see everything that's on the floor with one of these installed in the dome light. Vacuuming inside the car after dark was absolutely no issue and It's nice to be able to go through the car wash when there is nobody in front of you anymore that late. Haha!I ended up returning them though, because I wanted to install blue foot well lighting for some ambience, and this light overpowered it to the point I couldn't see the blue anymore.
Danno
Reviewed in Canada on January 14, 2022
Received the bulbs today, tested both to make sure they work and they do as I only need 1 for my Dome light!!!They are very bright, so make sure your interior lights are off before installing. or they will blind you temporarily....lol!!Fit our 2010 Grand Caravan fine, just make sure to place the bulb equal distance in the prongs.I didn't need slide in a 1 OHM resistor between the bulb and the prongs to prevent flickering of the lights when they fade off!!Yes that's what you need to do with some LED bulbs to prevent flickering for the interior and works great!!Just place each end of the1 OHM resistor in the prongs and plug the bulb on top to hold it and that will prevent flickering.You're welcome!!These bulbs didn't require that and the lights faded off without flicker!!Will see in the next little while how it goes.Also ordered the lights for the tail gate that are almost just as bright!!Can't wait to see how bright it will be after that!!Keep you posted!
John
Reviewed in Canada on August 30, 2021
I used these bulbs to replace the map lights in my 08 charger. After removing the lens and metal shield, I installed the bulbs. The metal shields won't fit after the leds are put in. These leds are insanely bright. Too bright for map lights. One of them started to flicker. I've removed them and reinstalled the original bulbs along with the metal shield.
Wolffe
Reviewed in the United States on July 12, 2020
These things are absurd. I wanted to replace the dome light in my 2001 Chevy Silverado because the incandescent bulb has a habit of melting the fixture and also just wasn't nearly bright enough. I could barely see anything in the truck at night. It's an extended cab with only one done light oriented towards the back. To get good brightness I would need an insane light. And this is that.This bulb is so bright it frightens my dog when it comes on. It causes some minor glare in the fixture even, though that's worth it for the enhanced light output. May not cause glare in your fixture, I imagine it will vary from vehicle to vehicle. For my application (only have one dome lamp) the light output is not excessive, but if you are planning to replace multiple dome lights in a larger SUV you may want to pick something a bit less bright.The design of these are awesome which results in a great fit. I love that the the LEDs are below the contacts, and the PCB can be pressed against the tip of the bulb contacts to stabilize the bulb and keep it from swiveling back and forth under high vibration. Worth nothing I did need to compress the bulb contacts to get a solid install, but I didn't even need pliers to do this (just finger strength). They could easily be pulled back apart to accommodate the traditional incandescent bulbbut considering said incandescent was melting my fixture, I doubt I'll ever go back.Love these bulbs and will repurchase in the future if needed. Hopefully they last a long time, I will update my review if I have longevity issues.