Sharon H. Seal
Reviewed in the United States on June 19, 2025
Useful
Lee Condosta
Reviewed in the United States on July 7, 2024
Well made. Would buy again.
Levi
Reviewed in the United States on March 16, 2024
This funnel is amazing 100% buy it, at northern tool it’s $23
Fabio A.
Reviewed in Brazil on November 27, 2024
Produto enviado não tem tubo flexível como anunciado parece nas fotos e informes. . O produto veio com etiqueta de identificação como flexível,mas é rigido
Homer J Simpson
Reviewed in the United States on August 27, 2022
This funnel is perfect for filling the transmission fluid in a 2d Gen Honda Ridgeline. The pour tip fits in the dip stick hole perfectly and is even ovoid so air escapes the filler tube with no burping happens. Highly recommend.
AWK
Reviewed in the United States on May 14, 2022
I purchased this specifically to put gas in cars from my jerry cans and the tip of the funnel is too big fit to fit into the fuel filler neck! The tip is not even perfectly round and measures 5/8" O.D. at the narrowest and 11/16" O.D. at the widest. I ended up putting a plastic funnel that fits into fuel filler pipe (i.e. "neck") and then put this metal funnel inside the plastic funnel while my wife held the metal funnel as I could not get it to wedge inside the plastic funnel. Should have sent this back from day one.
Andrew Kerr
Reviewed in the United States on November 23, 2022
I bought this for a kubota tractor where they put the hydro oil filler in an extremely inconvenient spot. In the past I had used a combination of funnels and gas can nozzles to reach it. This thing is amazing and I can imagine I will use it for other purposes, like my jeep which has an oil cap directly under my air intake, etc.
J. E. Lewis
Reviewed in the United States on January 10, 2021
This is a decent quality funnel. It works well, doesn't leak, and the tube holds position relatively well. When I got it the tube was VERY stiff, but I worked it back and forth a bit and now it's perfectly flexible in any direction. My only issue is that the OD of the spout end is too big at 0.7 inches. So I had to modify it with a smaller diameter brass tube and some JB Weld epoxy putty. I can't count the size against the funnel because otherwise it's of good quality and the spout size only matters to my own specific purpose.
Wesley Watson
Reviewed in the United States on July 22, 2020
I have a Subaru Forester, that runs on unleaded gas. Nothing unusual. I bought this funnel to fit into the spout where you normally put gas in at the pump, and stay upright. However, the only way I could get the funnel to get past the "unleaded gasoline inlet restrictor" was to remove the thing that was crimped on to the end of the flexible tube of the funnel. After that was removed, the flexible filler tube went down into my car's gasoline filler neck and the funnel stayed upright so I could pour gas from a container into the car's tank. The funnel is great now!
RaymondZhuang
Reviewed in Canada on July 31, 2018
not flexible enough