Your cart is empty.
Your cart is empty. loop strap and a magnet.
Loop strap size:38cm*2.5cm (15in*0.98in)
Feature:
Solves almost any hanging and positioning problem you may face.
The universal hanger allows you to hang your meter on nails, hooks and many other objects.
Package Including:
1 x loop strap
1 x magnet
Charles Etheridge
Reviewed in the United States on February 22, 2025
Great product and service 👌.
Joe
Reviewed in Canada on March 8, 2024
see headline
Patio Dweller
Reviewed in the United States on March 30, 2024
This works, but it is not quite the same as the original strap that comes with the meter I have. It is also cheaper than the name brand, and it does what is required. The magnet seems to be comparable to the original and supports the meter for any normal application. Note that some meters have the slot on the back of the case and other, very similar meters do not, so you might want to check your meter and set your expectations accordingly.
ABC
Reviewed in the United States on February 24, 2024
Works with my older Fluke meter. Magnet is nice and strong and I have never had it fall off anything I have attached it too (ferrous material of course).
Stevie johnson
Reviewed in the United States on December 17, 2024
Nice strap
珽竣
Reviewed in Japan on November 11, 2024
方便好用
dan
Reviewed in the United States on October 7, 2024
It works well with the fluke 902fc hvac meter. Strong enough to keep the meter where you want it on the furnace ac or duct work.
William Fisher
Reviewed in the United States on October 30, 2024
This magnet is perfect. I have the 116 HVAC multimeter and it fits great and the magnet strength is super strong you are not going to have to worry about it falling or slipping on surfaces. The only thing I'd say is I wish the strap was a little shorter it sits about 6" away from the meter fully extended, but that's just a preference. There's no need in my head to spend thr extra money on the name brand this will do the job just fine.
Math
Reviewed in Canada on August 31, 2023
Juste parfais! Bonne achat comparé au autre vendu par fluke
Alan D
Reviewed in the United States on November 10, 2023
Magnet is strong, it holds a chunky Habotest/Kaiweets HT208D on a 3/8 " dia. screwdriver- even better on actual flat surfaces! Magnet is in a flexible rubber holder. Caution- width of strap is 0.98" (in description and as measured). This was too wide for my meter slot, so I used a 0.79" strap that I had. The orginal strap could also have been cut thiner. $11 seems like a lot, but the product quality is inline with the value of meters that depend on it.
Carlos esquivel garza
Reviewed in Mexico on October 10, 2023
Llego antes de lo que decia amazon y tiene buen agarre a las zonas metalicas no se cae con el peso del amperímetro ,ya habia comprado uno chino se caia con el peso excelente producto
Mark in NC
Reviewed in the United States on March 10, 2022
This is a good magnetic strap and is a very useful accessory for a multimeter. I bought this to use with my Extech 355 full sized multimeter weighing 0.82 lbs. The strap holds this meter very securely - no sliding of the meter down the wall. Users should remember that magnets work best on plain steel and iron. Stainless steel is much less magnetic (depending on specific alloy) and may not hold as well on those surfaces. I am pleased with this purchase and would buy it again, if needed for another multimeter.
Bernhard E.
Reviewed in Germany on January 5, 2021
Der Magnet ist viel zu schwach um ein Multimeter aufzuhängen. Finger weg.The magnet is far too weak for its intended purpose, hands off.
Recommended Products
