Your cart is empty.
Your cart is empty.4.4 out of 5 stars
- #77 in Two-Way Radio Batteries
Wladimir Baez
Reviewed in the United States on March 3, 2025
genial
Roland Morin
Reviewed in Canada on February 14, 2025
Pa du tout dès bonne batteries
Customer
Reviewed in Canada on January 5, 2025
Good so far
Betty
Reviewed in the United States on January 12, 2025
Used to replace my walkie talkie’s batteries ,fit perfectly , i keep the unit charging all of the time , I would buy again worth the value, had them for a while now and the batteries show no problems
kabal rivera
Reviewed in the United States on September 13, 2024
Desde que la compré está funcionando perfectamente hasta el día de hoy
AJ Tissier
Reviewed in the United States on August 24, 2024
Perfect fit replacement for failed and leaking batteries in a couple of Uniden GMR638
vitali
Reviewed in Canada on May 19, 2024
Good seller.Very good item.Thanks
rf-sprinter
Reviewed in the United States on December 14, 2024
Has been working well as a replacement battery in my two-way hand-held radio.
Richard Fletcher
Reviewed in the United States on December 13, 2024
Drops right into my walkie talkie set. Getting ready for the SHTF.
Customer
Reviewed in the United States on October 26, 2024
Seems to work fine.
Rudy
Reviewed in Canada on April 20, 2024
Purchase these battery packs for our walkie talkies. Unfortunately only one was usable, the other would not charge, completely deadLuckily were are still able to use AAA batteries in the walkies.Will order again because of the low costHopefully both will be usable🤞🏻
Luis Angel Torres Orozco
Reviewed in Mexico on July 12, 2023
Excelente calidad y desempeño
Don
Reviewed in the United States on February 2, 2022
Uniden old walkie talkies needed new packs, these are the correct replacement and about double the mAH of the originals. Initially no power out of the box, but they did charge fine inside the walkie talkies. After about 6 hours, still no power on for the Unidens. I fiddled with the packs with the cover off, finally figured out these don't press down far enough for the + and - to make contact.The problem is the triangle "nib" at the top of the pack is mis-shaped compared to the Uniden original, and won't push the pack down far enough. I really wanted the 1000mAH so I made shims from thick paper (3x5 index card) and taped these to the top of the pack. Much snugger fit, and now these make the correct contact in the bottom of the battery case. The paper shims need to be cut so they don't interfere with the battery cover, if they stick up the case cover won't snap closed.I've left both Unidens on standby for over 12 hours and no decrease in the battery charge indicator, pleased with the charge life in these.
Recommended Products