Your cart is empty.
Your cart is empty.JT Sprockets ensures maximum durability and performance through accurate machining and using only the best grade of SCM415 chromoly steel alloy. Heat treated and hand finished to perfection, all JT Sprockets meet or exceed the highest possible quality standards for the powersports industry. Each sprocket goes through 10 quality control checks before it leaves the factory.
Jellyroll Johnson
Reviewed in the United States on June 23, 2024
But I wouldn't bother buying it as the front sprocket of the Raven is a 17T to begin with.I went ahead and replaced mine because the JT sprocket looked and felt like better quality manufacture than the stock sprocket.
Nate
Reviewed in the United States on May 27, 2024
Great quality an easy to install.
BMC
Reviewed in the United States on December 7, 2024
You'll have to mount sprocket cover first, then feed chain onto sprocket, but does work and fit.
STEPHEN M ARTHUR
Reviewed in the United States on December 14, 2024
Couldnt have been more simple, Remove the sprocket housing cover, use a 10mm socket with an extension to make it easier and remove the two screws holding the sprocket in place. pull the old one out carefully and clean the area while you have it open. then just place the chain on the sprocket and put the new one back onthe same way. all in all took about 15-20 minutes. These particular Jt sprocket are completely compatible with a hawk 250 and other variants of this bike.
jdogg
Reviewed in the United States on November 27, 2024
I have a couple Chinese made Motorcycles that use this as a front sprocket.They originally had a 15 and a 16 tooth sprocket on the front, being a lighter rider (under 130 pounds) I don't need all that torque to climb vertical telephone poles the 15t has... and the 16t helped stretching the gears a little bit, but RPMs are still screaming at highway speeds in final gear.Moving from the 16t up to a 17t, I lowered the RPMs about 400 at any given speed. Was also able to get these little 198cc Lifan engines to get upwards of 120 miles per gallon on a few trips after the sprocket change.Carefully check clearances before you go for a ride, some engines have just enough space for the 16t as the largest sprocket.
Ron Paugh Jr
Reviewed in the United States on October 25, 2024
purchased as an upgrade. works well thank you.
Wrenchturner
Reviewed in the United States on April 15, 2024
Easy to install, improved top end speed, now engine rpm's don't rap up so high
Jn Westbrook
Reviewed in the United States on September 24, 2016
Fits the Hawk 250. Quality product.
Recommended Products
$19.99
$ 9 .99 $9.99