Your cart is empty.
Your cart is empty.Product Description
NOTE:
Please be careful when choosing the size of the pipe fittings for your projects.
Jake
Reviewed in the United States on January 13, 2025
I used this combined with fittings to do pressure checks for water fittings on injection molds. Air lines in our shop are usually around 110 to 120 psi. This is still holding up after many many uses.
Jeff's Cave
Reviewed in the United States on August 4, 2024
The media could not be loaded.
Ryan
Reviewed in the United States on May 16, 2024
I’m using this on an air line with about 120 psi of pressure. When I first connected it, I hadn’t paid attention to the little arrow stamped into it. The result was my initial disappointment because it wasn’t completely sealed and was letting air through. I then saw the arrow and tried installing it with the flow in the correct direction and it works great!
Metalhead690
Reviewed in the United States on October 27, 2024
Used it on a car lift works great
crashradius
Reviewed in the United States on January 13, 2024
Have purchased this valve before using it in several projects, works well, very durable and very quick shipping
Mouse Jockey
Reviewed in the United States on December 19, 2023
Ordered this valve for use as a hand control for a sprayer.Works great - except i had to drill a pilot hole in plunger for flow to actually flow.Nice valve, ok price - but if you don't get any flow check your plunger for a flow hole.... :|
Dorothy
Reviewed in the United States on April 3, 2023
UPDATE:After inspecting more I noticed that there appears to be a rubber o ring inside this valve. While this would suffice for most, I can not use it because I bought it to add hydraulic fluid to an aircraft landing system, and some rubber orings will disintegrate upon contact with this type fluid. Therefore, I am sending it back. I still think it is an excellent product but just won't work for my application.==== It says it’s a check valve and has an arrow on the side, but it’s not a check valve as you nan blow thru it from either side. It makes no difference to me as I don’t need a check valve.
John A.
Reviewed in the United States on August 17, 2020
Good product and well built. This push button is being used in a custom built water dispenser for 5 gallon water bottles running at 60PSI. By using a pump that turns off at 60PSI and on at 40PSI this button is used to allow the water to flow when pushed. I have a mechanical pressure gauge installed inline and after 4 hours there is no pressure loss and no leakage when in standby or while being used.i have tested several push buttons and this one has functioned flawlessly. I highly recommend this product.
Recommended Products