Your cart is empty.
Your cart is empty.IVY Classic Industries is dedicated to producing a comprehensive, quality line of power tool accessories and hand tools. IVY Classic Drill Arbor Adapters adapt 1/2-inch arbor holes to fit a 1/4-inch arbor shank. These arbor adapters are zinc-plated and feature alloy-steel construction.
RickCNC
Reviewed in the United States on July 3, 2024
Does excellent job on French polished guitarsVariable speed drill makes it easier to control heat and burn though
R. Tidwell
Reviewed in the United States on December 28, 2024
Great addition for holding polishing wheels.
Roy A. Morales Jr.
Reviewed in the United States on April 11, 2024
I'm happy
Salvia
Reviewed in the United States on July 20, 2023
I use them on drill presses with inverted lapping wheels...Works great but a bit pricey for what it is.
User of Products and Commmodities
Reviewed in the United States on November 18, 2023
These are about 0.036" undersized. So if you're expecting a 1/2" diameter arbor adapter, you're not getting that. While these arbor adapters can be used on lower speed (drill motor) applications and simple, non-concentric uses, such as wire wheels with flanges, don't expect to use them on any higher speed or concentric required devices, like abrasive wheels, grinding wheels, rubberized abrasives, or any wheel or use that must run concentric and true. I'll adapt mine by using plastic shim stock, but clearly they are limited in their use. Don't take chances with anything that must run true with this adapter, unless you're a machinist, you won't get there from here. Be Safe!
Roboprof
Reviewed in the United Kingdom on February 11, 2022
Because the washers are not dished the clamping pressure is near the centre making it more likely that clamping a grinding wheel might make it crack. Plain washers are ok for mounting buffing pads or wire brush wheels. It's a pity that a very large screwdriver is needed to tighten the wheel in place, a hexagonal head that could be tightened with a spanner would be better. The packaging claims that the arbor can clamp a wheel that is up to 1 inch thick. Not so. The arbor only has the capacity to clamp wheels up to 0.6 inch thick, 0.7 inch if you leave out the washers. It has a maximum speed of 6,000 rpm. It's made in China.
TheRG
Reviewed in the United States on June 9, 2021
Works just fine.
T Markworth
Reviewed in the United States on March 11, 2016
Not much to say here. It's a generic arbor for using cheap shaft mount tools (such as wire wheels) with a die grinder or drill. I got this to use 3" for my angle die grinder and it works quite fine.For the sake of fun facts, the thread is 1/2-13 LH and the nut is some kind of hardened steel with O.D. of 3/4.
One Degree Life
Reviewed in the United States on December 20, 2015
Good quality, but expensive for what it is. Can find basically the same thing at local hardware stores for less than half the price. Look for Ryobi at HD, for example. Went to buy one there, but this got left in my Amazon cart and I checked out on my phone, not realizing it was still there. No sense sending it back. I paid 9 for this, HD has them for under 4.
Recommended Products
