Your cart is empty.
Your cart is empty. Unadjustable speed
Contact
Contact Ratings: 1H
Contact Material: silver alloy
Contact Load: 10A
Contact Switching Current: 10A
Contact Switching Voltage: 12V
Rating
Rated Voltage: 12VDC
Rated Current: 10A
Operating Voltage: 11VDC ~ 15VDC
Test Voltage: 13VDC（±0.2DC）
Test Temperature: 20°C
Switching Load: 0.1W ~ 150W(0.02A ~ 20A)
Coil Power: 0.36W
Max. Power: 150W
Flashing Frequency: 85 times per minute
Duty Ratio: 30% ~ 70%
Operating Temperature: -40°C ~ +80°C
Billy Boy
Reviewed in the United States on March 7, 2025
Works great as always
Ken
Reviewed in the United States on February 20, 2025
Works very good
Mark gnomirello
Reviewed in the United States on February 18, 2025
great deal
Tim H.
Reviewed in the United States on February 10, 2025
had some new legs that fed back so when my running lights were on, my blinker lights (also led) were on also... odd I know. the would blink off when working.... and they didn't like the low resistance of leds, so they worked much more normal while I was hooked to a trailer. anyway, ordered these with the ground wire and now everything works as it should!
Mark A. Jones
Reviewed in the United States on February 1, 2025
These do work on older GM vehicles. The non-grounded version of these flashers will not work. I have converted a 1970 Chevelle and a 1972 C-10 to completely LED bulbs and both needed this grounded style of flasher to function correctly. Note: the workmanship on these units isn't great. Grounding wire isn't installed very well. It appears that the hole for the bare wire strands is not large enough so many of the wire strands are not soldered to the connection but are wadded-up on the back side of the hole. Those stands are doing nothing. There is nothing helping secure the ground wire. If the wire is pulled it will likely fail since it is not properly soldered to the circuit board.
Dizzyfish
Reviewed in the United States on January 19, 2025
I ordered these so that I could switch to LED bulbs on my '90s era John Deere tractors. They are not plug and play in my application. Polarity is opposite of what I needed, so I had to pop the terminals out of the harness and switch them around to match the blinker module. Once that was done they worked as they should. I'm not sure how well they will hold up. They are made of cheap plastic.
Holmgren94
Reviewed in the United States on December 11, 2024
These relays work well with LED lights for turn signals and hazards. Be aware they are silent and make no noise when signals are on. We'll see how long they last but they work as expected.
billdit
Reviewed in the United States on November 21, 2024
As you can see in the picture, it exploded when applying power via a switch. In the picture on the left side is another flasher with a lower amperage rating that was used in the same scenario with no issues. I have a dozen different flashers from different sources that I’ve used and never had a single issue until this particular flasher that exploded almost causing a fire. I do not recommend, but if you do purchase this flasher, I would test it before placing it in service. I possibly received a defective one, but I won’t be ordering any more of this particular flasher.
Recommended Products
$10.99
$ 4 .99 $4.99