Your cart is empty.
Your cart is empty.
Package:Intake Manifold Boot*1
Manufacturer Part: 5GH-13586-00-00
This Accessories fits the following models:
YAMAHA Grizzly 400 2007-2008
YAMAHA Grizzly 450 2007-2014
YAMAHA Kodiak 400 2000-2006
YAMAHA Kodiak 450 2003-2006
YAMAHA Wolverine 450 2006-2010
cathy
Reviewed in the United States on January 29, 2025
Product worked fine after I drilled out the mounting holes to a larger diameter that allowed the manifold to line up with the cylinder.
Onie fields
Reviewed in the United States on June 21, 2024
Didn’t fit the 03 Yamaha 400 I ordered it for
Shawn
Reviewed in Canada on March 30, 2024
Fit good, quality seems good
Customer
Reviewed in the United States on February 17, 2024
The bolt holes do not line up. Being that you’re tightening into an aluminum head, it would be very easy to cross thread and make a mess. I had to drill the holes bigger. Also, the o ring is too big for the groove. So it’s a pain to get it to stay in unless you use a gasket maker to glue it in.
Me
Reviewed in the United States on January 27, 2024
Good fit
Alex Lang
Reviewed in the United States on April 25, 2024
Fits perfectly and works well
Kelly welch
Reviewed in the United States on April 18, 2024
Fast delivery and fits perfect very durable
Joe P
Reviewed in the United States on November 5, 2023
For the money I'm good making it work but will have to file bolt holes to make it fit as many reviews have mentioned.
Arnie
Reviewed in Canada on October 31, 2023
Did not fit my 2006 Kodiak 450 YFM45FAV.Good quality but fitting description is off.Ordered this because my Kodiak would only run on full choke and backfiring so suspected engine intake air leakage. When it was running I sprayed carburetor cleaner around the OEM boot and engine revved up.Tight getting this new boot installed with same results. Turned out to be the Pilot Jet was plugged. Cleaned carb and put the OEM boot back on, back to normal running. I lubed the mounting O-ring on installation and no longer have revving when spraying carb cleaner in this area.The part number on this matched the OEM but was almost 2mm less on the aluminum intake diameter and mounting holes.Rubber boot to carburetor fit fine.Return process was exceptional.
Recommended Products
