Your cart is empty.
Your cart is empty.Product Description
Compatible Differentials:
- For Dana 30 Front, Crush Sleeve Design, Grand Cherokee
- For Dana 30 Front, Standard Rotation
- For Dana 30 Front, JK Non-Rubicon
- For Dana 30 Rear
- For Dana 30 Front, Crush Sleeve Design, TJ Wrangler
- For Dana 44 Front, Standard Rotation
- For Dana 44, 19 Spline
- For Dana 44 IFS Front, '92 & older
- For Dana 44 IFS Front, '93 & newer
- For Dana 44 Rear, Jaguar
- For Dana 44 Reverse Rotation Front, JK Rubicon
- For Dana 44 Rear, JK Rubicon
- For Dana 44 Rear, Non-Rubicon JK
- For Dana 44 Rear
- For Dana 44 Front, Reverse Rotation, Straight Axle
- For Dana 44, TJ Rubicon Wrangler front
- For Dana 44 Rear, Corvette
- For Dana 60 Front, Standard Rotation - 30 Spline
- For Dana 60 Rear - 16 Spline
- For Dana 60 Front, Reverse Rotation
- For Dana 30 Front, Reverse Rotation
- For Dana 60 Front, Standard Rotation - 35 Spline
- For Dana 60 Rear - 30 Spline
- For Dana 60 Rear - 32 Spline
- For Dana 60 Super Rear - 33 Spline
- For Dana 60 Rear - 35 Spline
- For Dana 60 Front, Standard Rotation - 16 Spline
- For Dana 60 Rear - 23 Spline
- For Dana 28, Independent Rear Suspension
- For Dana 44, TJ Rubicon Wrangler rear
STEP 1
- Take off the bolts to remove the carrier from the axle assembly.
- NOTE: There are shims in here so make sure that you don't mess those up.
STEP 2
- Remove the old inner seals on both sides. Then clean any dirt out the tubes.
STEP 3
- Put the new seal on the puck. Then place the seal and the tool in the differential.
- Tighten the nut until the new seal is in the right place.
STEP 4
- Remove the tool. Then repeat the Step 3 to install the new seal on the other side.
Keith Nolf
Reviewed in the United States on February 8, 2025
Worked great installing the rear axle seals in my 2008 Jeep Wrangler. Nice tool to have in your tool box.
Customer
Reviewed in the United States on February 3, 2025
This tool for putting in seal in my dana 44 axles works great, awesome product and a time saver
Missi Moutardier
Reviewed in the United States on January 26, 2025
Used on a Dana 60. OEM seals take quite a bit of force to install. I would not recommend installing without a tool like this.
Alejandro Medrano
Reviewed in Mexico on August 13, 2024
Herramienta de muy buena calidad para colocar los sellos, muy practica . Me sorprendio lo pesado y la buena calidad, la utilice para cambiar los sellos del diferencial de un jeep jk 2007
Roy leach
Reviewed in the United States on July 29, 2024
Easy to use and works great.
Chase Hamilton
Reviewed in the United States on June 15, 2024
I work at a Chrysler dealership and have used this many times, It works great on the front axle seals of jeeps. Worth the buy, Saves you time of digging through the special tool room and hoping someone put it back.
Customer
Reviewed in the United States on December 31, 2024
Made installing the inner seals a breeze. 2017 Wrangler.
MOBS
Reviewed in the United States on November 8, 2024
Had to grind down two flat spots on the very end so another wrench could grip it. I did not have another nut to put on it so had to grind it. Once there was tension on the rod it kept spinning and wasn’t pressing in the seal, used the second wrench to hold it place. Worked perfectly once that little obstacle was passed
Poor mechanic
Reviewed in the United States on October 21, 2024
Used in a 2002 jeep Grand Cherokee Laredo, front axle. It got the job done. But I think it would've been better it the tip of the big side was angled at a 45° in. At least 1/8 inch in. Because the only problem I had was it fit the hole perfectly. And it set above case with the seal in place. So I kept getting caught on the case. So I had to use the small side, to set the seal in the hole a bit. Till it was below the lip in the case. And turn it around and use the big side. I wish I took pictures to show. But if you buy this and use it. You'll know what I'm talking about. It'll get the job done. so it works great, easy to use, and looks like I could use it for other uses too.
A2J
Reviewed in Australia on July 7, 2023
Handy tool, works as advertised.
Michael Whittaker
Reviewed in Australia on March 19, 2023
Great tool. Makes fitting seals easy. I will get a lot of use out of this
Luke Endacott
Reviewed in Australia on October 22, 2022
Works great
Recommended Products