Your cart is empty.
Your cart is empty.The iLIVING Shutter Exhaust Fan is perfect for removing excess heat, moisture, and unpleasant odors from virtually any commercial location, including restaurants, factories, warehouses, barns, and greenhouses. This fan features aluminum blades, OSHA compliant wire guards, and automatic shutters that open and close in tandem with the operation of the fan. The completely enclosed motor is thermally protected and permanently lubricated. Equipped with the newest Thermospeed Controller which can easily control the temperature and speed. Auto cycle ON/OFF at your desired temperature. The fan comes fully assembled out of the box.
Elbert Rivas
Reviewed in the United States on January 5, 2025
Ok im single and I have friends that like to smoke, well this thing pulls it right out the window NO SMELL !! ITS SO STRONG 💪 😁 that in the summer when I get home I turn it on to take out the hot air it works great 👍. Yes it's a must ,to fix any problem. Don't worry about the light bill like, 🤔 I did,, its only used when u need it , it works so good u don't need it on for long .👍
BillG
Reviewed in the United States on September 2, 2024
This fan is light weight but well constructed. Installation could not have been easier. I cut a 16.5 inch square hole with a jig saw, using a blade rated for thin metal. Then I used a permanent marker to mark the location of the eight mounting holes on the wall and drilled them out to take 1/4 inch by 1 inch bolts with lock washers. The fan is quiet and there is no vibration whatsoever. Some reviewers have said they felt that they needed to construct a frame. I did not find that to be necessary. The thermostat works very well. I find the fan speed control to be of little value as any speed less than full will cause the louvers to drop a lot. If you only need the fan on when you are in the building you can save some money by using a switched outlet and forgoing the thermostat.
Matt
Reviewed in the United States on September 11, 2024
This is the second shutter fan I have installed in two of my projects. This specific one is in my 30x50 shop to keep the summer heat down. It works great. Can tell a difference in the before and after. Don’t get me wrong it will not cool the building down to 80 on a 100 degree day, but it definitely helps keep it from being 110 degrees in my metal shop and keeps the air flowing. I just set the thermostat to about 88-90 and let it do its thing.
Don Clark
Reviewed in the United States on June 6, 2024
Excellent volume of air. Easy to install. Installed in compressor room to help draw warm air outside so the compressor runs cooler.
ANNA EDWARDS
Reviewed in Canada on June 28, 2024
Works like a charm and is very powerful!!! We are very satisfied with our purchase 👍🏻
Adam wade
Reviewed in the United States on September 6, 2023
Easy to put together and install. Some of the best parts about this product are it's shutter design, adjustable fan speed and ability to cool my greenhouse down quickly and efficiently. The thermostat is also a very helpful tool as it turns on at the set max temp to ensure the area stays comfortable in temperature during the day!
Steve Cross
Reviewed in the United States on June 8, 2023
I received this fan today to use as an exhaust fan in my 2 car garage. Packing was nice with plenty of styrofoam for protection. Mine looked new with no defects noticed upon primary inspection,and contained the fan and temperature/speed control,as ordered. The first thing I noticed was that the power cord was not wired into the fan motor. No big deal because simple wiring instructions are included and I'm experienced in wiring as well,but the ad did not mention "wiring required". There were a couple of small items missing though. The bulkhead fitting for the electrcial junction box was missing,even though the instructions stated that the hardware included aforementioned bulkhead fitting. I happen to have 1 that would fit or I would've had to make a hardware store run. There were also a couple of tiny rubber plugs missing from some holes in the body of the motor. The holes are probably from manufacturing the body of the motor,and there was 1 plug in place but 3 were missing. I filled the holes with a little bit of silicone and continued on. The rest of the initial inspection and test-run was pretty well standard. The fan and controller worked as advertised,although I did not try to set the temp control portion. Turning the temp control knob all the way counter-clockwise bypasses the temp control feature,by the way. There is a power on/off switch next to the speed control knob. The speed control worked well and the fan responded accordingly. One note--if you have the speed control on the minimum speed and turn the power off,the next time it is turned on,the fan will run at full speed for a second or two before the speed controller backs it down to low. Apparently this is normal as mine did it several times when I would turn the power off and back on,so I figured it was just how it works. The slats worked well with no binding and the fan itself seems relatively quiet for a 16" fan. All-in-all,a decent fan for the money and yes,I would buy it again.
Dermit The Hermit
Reviewed in the United States on June 4, 2023
The media could not be loaded.
scooby doo
Reviewed in the United States on October 1, 2023
We often use ILiving fans (different types of fans but same manufacturer) in rental properties and they last a very long time. So, when we enclosed our carport where our AC condenser is located and needed to exhaust the heat, we selected another ILiving unit. We opted for the 16 inch thinking the high CFMs it would be adequate for the purpose and located it 2 feet above the condenser where the unit exhausts. Turns out the residual heat hits the ceiling and blows downward (as opposed to rising as one would expect heat to do :). As a result, we ended up having to purchase and install a second unit. The units are quiet, run as expected with adequate temperature and speed settings responding as they should. Sadly, in retrospect, we should have purchased a larger unit and located in a bit differently. We do recommend this product but anyone attempting to use it for the same purpose as we did might want to carefully evaluate it's placement ... and buy a unit with a larger surface area than we did.
Recommended Products
