Your cart is empty.
Your cart is empty.The W6VB3SD2 is the perfect tool for all of your collated screw needs. The W6VB3SD2 has a maximum speed of 2,600 RPM and an awesome torque rating of 139.6 in-lbs. This is the perfect combination of speed and power to tackle all of your decking and subfloor projects. With a screw capacity from 5/8" to 3" and a diameter of #6-#12 screws, you can use this tool in varying applications. The 20" extension shaft allows you to stand and fasten down or up without having to get down on your knees or stand on a ladder. The W6VB3SD2 has a 24.6 foot long cord so you can move around your jobsite and you are not tied to the power outlet. The W6VB3SD2 is the perfect package when it comes to a collated screw driving tool. Standard accessories: SuperDrive extension, #2 Phillips, #2 Square and #2 Lox bit, Case Hardened Drywall Nose Piece, Case Hardened Decking/Subfloor Nose Piece, Side Handle.
Victor L.
Reviewed in the United States on June 5, 2018
I will update my review once I have used the machine on a job, however, I can not believe for $250 a hard case is not included. I can see this would be easily damaged in the truck or in storage, so now I'll be paying to buy a hard case separate. From bad to worse. This may be the worst power tool I've ever used. Fiddling with the drive depth for 40 minutes, unable to get a consistent countersunk screw! 1/3 are set good, 1/3 are over-driven from 1/8" to point of blow through, and 1/3 "clutch out" early and are left sticking 1/8" to 1/2" above drywall! So now, I have to change tools and use my regular cordless to fully sink the screws! After messing around for over TWO hours and getting only 2 sheets of drywall up, I will be returning this tool. I would have gotten twice as much accomplished just using my screw gun but now that I have several pails of collated screws, I'll probably just get the Senco. All my tools are DeWalt but they don't have a gun that will go to 3" screws. I also see now this model has been discontinued by Hitachi - and I know why!
Stephen J. DeFronzo
Reviewed in the United States on June 30, 2018
BUYER BEWARE! Ran it for 3 hours and then it stopped driving screws. No obvious reason since everything was set up correctly. Had to stop the job while I tried to repair it. Had to go to manual drilling with my Dewalt. Returned it to Amazon
Rick
Reviewed in the United States on June 21, 2018
No longer a "pain in the BACK" as this takes all the bending out of the equation! Occasional double advancement of screws after setting a screw but nothing to worry about.
Floyd Campbell
Reviewed in the United States on May 14, 2017
Screwed 3,000 screws in my new deck in one day. Easy to operate, No jams, etc! Never build a large deck without this screw gun.
Robert Stuart
Reviewed in the United States on March 28, 2017
The trigger does not work have tried to message them threw here to see what we can do to correct the situation. I messaged them again last night and am hopping to get a reply today about getting this fixed.
MB
Reviewed in the United States on January 6, 2017
I bought this unit because of its value and it turned out to be a good decision. It feels like it's better quality than my SENCO. It's also versatile in that you can remove the extension and use it for walls or ceilings. I used it to screw down 800 sf of decking using 3000 screws with only slight wear on the bit. Misfires were rare and always because of something I did wrong. Nice long cord, light weight, powerfull hitachi driver and easy adjustments. One of those tools that are worth the investment even if you use it on one job (decent size job). No back or knee ache was important.
Floridave
Reviewed in the United States on April 28, 2017
this tool is a must if you want to set screws perfectly, and save your back, in the time it takes a typical handyman to put one screw in with a cordless driver..this will put in 5-6 easy...excellent construction, and very lightweight for the power.
Joey Threatte
Reviewed in the United States on July 20, 2016
We have a 53 year-old construction company and specialize in upscale custom homes. We recently replaced our 12 year-old Senco collated screwgun with the Hitachi and immediately put it to test. It performed very well. No glitches, No problems at all. The first day out we drove over 5000 screws. I would recommend this gun to any production crew.
Recommended Products
