Your cart is empty.
Your cart is empty. Description:
The DRV8871 device is a brushed-DC motor driver for printers, appliances, industrial equipment, and other small machines. Two logic inputs control the Hbridge driver, which consists of four N-channel MOSFETs that can control motors bidirectionally with up to 3.6-A peak current. The inputs can be pulse width modulated (PWM) to control motor speed, using a choice of current-decay modes. Setting both inputs low enters a low-power sleep mode.
The DRV8871 device has advanced currentregulation circuitry that does not use an analog voltage reference or external sense resistor. This novel solution uses a standard low-cost, low-power resistor to set the current threshold. The ability to limit current to a known level can significantly reduce the system power requirements and bulk capacitance needed to maintain stable voltage, especially for motor startup and stall conditions.
The device is fully protected from faults and short circuits, including undervoltage (UVLO), overcurrent (OCP), and overtemperature (TSD). When the fault condition is removed, the device automatically resumes normal operation.
Features:
H-Bridge Motor Drive Module
Drives One DC Motor, One Winding of a Stepper Motor, or Other Loads
Wide 6.5-V to 45-V Operating Voltage
565-m Ohm Typical RDS(on) (HS + LS)
3.6-A Peak Current Drive
PWM Control Interface
Current Regulation Without a Sense Resistor
Low-Power Sleep Mode
Small Package and Footprint
8-Pin HSOP With
Integrated Protection Features:
VM Undervoltage Lockout (UVLO)
Overcurrent Protection (OCP)
Thermal Shutdown (TSD)
Automatic Fault Recovery
Package included:
2 x DRV8871 DC Motor Drive Modules
Keith T. Strang
Reviewed in the United States on September 23, 2024
I don't understand how I can put a decent load on these and they don't get hot like other DC motor drivers. Very impressed with them so far. They did come with all pins/terminals needed so far. I suggest not using the terminal blocks as the wires pull out of them so easily. I just soldered wires direct to board.You also don't need to supply logic 5V to the board either... I jsut connected pwm ground and power to the inputs and all good. The board will get power from the power in.
Devin Hunter
Reviewed in the United States on September 2, 2024
It's a waste of time to get a sensor that does not have the pins needed to fully utilize the sensor. Keep that in mind before buying
Recommended Products
