Your cart is empty.
Your cart is empty. Description:
The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating.
Features:
Solar panel input: 4.4-6V
Max charge current: 500mA
Interface: 2-pin JST connectors(or PH2.0)
Short circuit protection
Continuous Charge Current Up to 500mA
Battery status indication ( Red : Charging , Green: Charged )
Support USB Charge (Micro-USB Connector)
Size:2cm x 4cm
Package included:
2* CN3065 Solar LiPo Charger Module
E
Reviewed in the United States on December 24, 2024
Build quality was alright, functions as needed for the most part, I thought this was a good value for the money spent, but the polarity was reversed so I had to reverse my wires for this item to work. Found out after I burned my hand.Small little board, charges alright, but such a mistake is potentially dangerous.
smaj100
Reviewed in the United States on May 15, 2023
These are awesome chargers, working great for power sensitive projects.
Kindle Customer
Reviewed in the United States on March 3, 2022
Dislike: the board is not reserse polarity protected and the jst connector was revered for the battery. This caused the battery to "smoke" the unit. Low current precludes you from supplying a load and charging a battery. You can do either, but not both. Solar cell charging may work in full sunlight. I never got it to workLike: Cheap, so no loss, until you can find or build a better unit.
carey schroeder
Reviewed in the United States on January 23, 2022
The media could not be loaded.
J. Challinger
Reviewed in the United States on June 13, 2021
This thing will use all of the power from the solar panel to light its "charging" LED before it puts a single drop of charge in the battery. Removing the LEDs made a night-and-day difference on my project with a 2W solar panel - went from barely powering the load at peak sun to charging the battery fully every day.Otherwise works great.
MammothWerks
Reviewed in the United States on September 4, 2020
I’ve used a few of these for development of a twin LiPo charge setup with a 6V panel that supplies 250mA, works great. Also tapped into a point on the circuit to charge via USB as well, all good. Not sure why someone else rated one star without explanation.
Wohn
Reviewed in the United States on November 12, 2020
The adaptable output current based on available input current is great, they are well suited for solar battery charging. No complaints.
Recommended Products
