Your cart is empty.
Your cart is empty.HHIP MT2 to JT3 arbor taper to chuck Morse taper arbor for adapting drill chuck to machine tools. Morse taper to Jacobs taper.
Andrew Arndts
Reviewed in the United States on August 20, 2024
the arbor on the particular drill chuck that was replaced by the one purchased was a pain to get out of my tail stock on my wood lathe. with the tang end with this one, no knock out bar needed.
John Hancock
Reviewed in the United States on February 3, 2024
finish is very good, but runout is 0.009 to 0.011 on Jt33 and 0.009 on the 1/2" shoulder close to the Jt33.In same collet, a fairly straight 5/8" Forstner bit (amazing how many Chinese bits aren't really, really straight), registered within 0.005 at the end. The Chinese Forstner bit shank measured 0.002 an 1/8 from the collet edge when that is to check the collet. Ironically, the 1/2" shank on this adapter was actually off a more. It seems to be slightly out of round.I got this to quickly install a drill chuck rather than change to collet assembly for not really critical work. It will work OK for that. Secondarily, it was to be for checking runout at the collet. Turns out not to even be as good as a cheap Chinese drill bit.BTW, chucked a US long shank 1/2" bit and it measured less than 0.0005 on the dial indicator 2" out from the collet end.I truly hope the Chinese build their military equipment to the same standards they make drill bits and ball point pens. ;)
Customer
Reviewed in the United States on December 30, 2024
fit and finish is good
newt96er
Reviewed in the United States on November 28, 2024
Arrived 4 days early! Runout was about .001Couldn't ask for better for the money.
Rod M.
Reviewed in the United States on January 1, 2024
Exactly as advertised
Dr. Roger L. McCarthy
Reviewed in the United States on January 8, 2022
I bought this item and then shortened the 1/2" shaft by half to conveniently hold it in a 1/2" drill chuck to give my 1/2" drill 3/4" chuck capacity. It works perfectly. The combination has very little runout.
kari ngai
Reviewed in Canada on June 11, 2020
Good product, great value
Mario Filion
Reviewed in Canada on February 3, 2020
tour a fer
Erik in MO
Reviewed in the United States on December 2, 2020
I was looking to add a drill chuck to my lathe's tailstock and found this which would allow me to use a chuck I got a while back with my lathe. The J33 fits the chuck snuggly and the MT1 taper fits my tailstock very well. When I upgrade my lathe to something with a MT2 tailstock I will adapt this to fit with an MT1-MT2 taper adapter. Excellent value!
Tiger
Reviewed in Canada on January 4, 2020
like expected
Ty
Reviewed in the United States on April 16, 2020
I installed this on my WEN benchtop drill press. I wanted a JT 33 chuck that didn't require a key, was more robust than the OEM chuck and this tang was required in order to use the JT33. I love have both this tang and the JT33 chuck. I haven't had any tension issues and the machining is very high quality. No complaints. Works as advertised.
John C
Reviewed in Canada on September 16, 2019
Great price and less no run out.
Customer
Reviewed in Canada on February 7, 2019
Use this on my 8" king canada press drill
Recommended Products
$87.16
$ 34 .99 $34.99