Your cart is empty.
Your cart is empty.S05 SCLCR06 Mini Indexable Boring Bar ~ Shank size is 5/16". ~ Minimum bore is .315". ~ Overall length is 4". ~ Neck diameter is .236". ~ Neck length is .985". ~ Suitable inserts are CCMT-21.5. ~ The insert screw is M2.5 X 6 (#2100-0070). ~ Torx wrench is a T-8 (#2100-0092).
Lee M.
Reviewed in the United States on September 21, 2020
I did not test this and will be returning this as I was looking for an 8mm minimum bore. This is more like a 10 mm minimum bore. The neck is .291" diameter, 1.17" length. Otherwise seems well made.
Cassie
Reviewed in the United States on September 16, 2020
Use this one everyday. Great reach, and good rigidity. There is a milled flat on both sides, so use a conventional tool holder without a V bottom
Andy Albert
Reviewed in the United States on August 16, 2020
Lot nicer quality than a lot of the tooling I have dealt with... Have bored half a dozen holes .375 over the starting diameter (.5 to .875), and a few .5 to .55, with no issues.
T. Smythe
Reviewed in the United States on November 25, 2020
I was in need of a smaller boring bar for inside boring on small objects in my mini lathe; so purchased this one to try. I have used it multiple times so far and the function is nearly flawless for both boring and facing in a pinch on aluminum. The Carbide insert is a large bonus and allows me to use it for harder metals other than aluminum. It is sturdy and the length is longer than I will ever need, but offers total area support by being inserted in the tool holder with all screws contacting the shank. The flat area on tool shank is a large benefit for increased holding power in the tool holder also.
Recommended Products
