Your cart is empty.
Your cart is empty.This V-Block Pair is numbered and matched and are precision ground for accuracy.1 5/8" X 1 1/4" X 1 1/4"1" capacity.
Mark fields
Reviewed in the United States on January 17, 2025
Did not have thumb screws like it shows. Has cheap Allen head screws. Clamps are near useless. Blocks are rusted.. Paint falling off clamps.
Scott R.
Reviewed in the United States on September 25, 2024
My application is a lot different than most people's. I'm using these in a laser lab to hold laser rods for testing. They'll do just fine for this. I noticed a lot of people have complained about the poor quality of the clamps that are included. I think they beefed them up in the interim, because the set I received appear to be quite heavy and stout. They're made from cast iron/steel with a 3/8(?) 8mm(?) SHCS for the bolt. Everything is heavily coated in cosmoline or similar material for rust prevention. I'm not too concerned about parallelism or flatness but they appear adequate. Considering a similar sized set from McMaster-Carr would run $300 and up, I'll take these!
Marc Lomax
Reviewed in the United States on July 30, 2024
Very nice and sturdy little clamping blocks
Robert A Miller
Reviewed in the United States on July 22, 2024
Works well for the use, I've always had good luck with Grizzly products including larger metal working and wood working equipment.
Mr Ed.
Reviewed in the United States on October 12, 2024
Blocks are getting rust right out of the box.Have dings on it.
Steve
Reviewed in the United States on January 17, 2024
V-blocks are great for the money and for small hobby mills. The clamps are trash.
don s
Reviewed in the United States on April 4, 2024
These arrived in excellent condition and are the perfect size for my mini mill (7" x 27" table/ 4" vise). All surfaces are nicely ground and there are no rough or sharp edges. They are well matched as a pair.
jorge beltran sanchez
Reviewed in Mexico on February 4, 2023
Más pequeños de lo que parece
Antony B.
Reviewed in Canada on November 26, 2023
The clamp was poorly made. Both unit had the same issue .The V-block seem to be OK.
alan
Reviewed in the United States on August 27, 2022
I was somewhat concerned when purchasing these as some of the other reviewers have complained that they are not match ground. For all intents and purposes mine are perfect. I inspected them on the surface plate and they are as precisely matched to each other as I can possibly measure. Haven't tested the clamps yet but they seem to be made better than some of the cast clamps you see in the v-blocks in this price range.
Henry-C
Reviewed in Canada on October 14, 2022
It’s a drilling block use for drilling in the right place accurately
Dennis Hirst
Reviewed in Canada on March 8, 2019
great
Recommended Products
$34.85
$ 17 .99 $17.99
$58.95
$ 29 .99 $29.99