Your cart is empty.
Your cart is empty.3.8 out of 5 stars
- #42,375 in Patio, Lawn & Garden (See Top 100 in Patio, Lawn & Garden)
- #99 in Grill Burners
Tomio Yamawaki II
Reviewed in the United States on February 9, 2025
The burner tubes fit like factory parts, and I had to angle the reflector ends to fit the back wall of the grill. The crossover tube comes as 2 pieces that slide into each other to adjust to the width between the 2 burners, it is too short for my grill even though it states it fits my model. Luckily the original was still in fairly good condition and I had to reuse it to complete the repair.
Crafty Barnardo
Reviewed in the United States on February 25, 2025
The carryover tube is about an inch too short. Every other part fits just fine. I had to order a different set of pieces that direct the propane from the first burner too the second one because the one provided with this set was too short.
steve m.
Reviewed in the United States on February 14, 2025
Did Not fit properly
Bryan Rogers
Reviewed in the United States on February 11, 2025
One of the parts didn’t fit the grill but most did so it was worth the price!
jim
Reviewed in the United States on January 9, 2025
Insure you buy the correct kit for you grill by finding the model number on the grill. Burner replacement is easy and strait forward. Be sure to completely clean it after you remove the old burners. The new burners go in easily just be sure they snugly set into the manifold. All the pieces you need are in the kit so don't worry if you lose the pins or end keeper from the back. All I needed was a pair of needle nose.pliars to do the rebuild.
Jodi
Reviewed in the United States on September 22, 2024
Easy to install. Came with everything you need. All the new hardware. Work like they should. The only problem is the cross bar is too short and falls off all the time and to install it one of the heat elements turned a little but inward. Quality material. Looks almost like the original. Burn very well. I would say worth the money. Not sure if they are rust resistant. We keep the grill closed and covered when not in use. I would highly reccomend these. Just make sure you know your grill model number to match up.
C. L. Trudell
Reviewed in the United States on September 17, 2024
Nice stainless steel materials, everything fits well except the crossover piece is too short even though it says this kit works with my model number grill
Valary G.
Reviewed in Canada on July 9, 2024
The Burners were too short for the 463365021 Grill. Needed to be 18" but burners in package were only 16"
Jolly Jan
Reviewed in the United States on December 16, 2024
Quick shipment. Quality A plus. Would purchase again!
Recommended Products