Your cart is empty.
Your cart is empty.An ACDelco GM Original Equipment Electric Brake Control Wire Harness holds secure against the adverse effects of vibration, abrasions, and moisture. They are the GM recommended replacement for your vehicle’s original components. These original equipment electric brake control wire harnesses have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Jay
Reviewed in the United States on November 18, 2021
It was exactly as what was described and was very quickly shipped.
aintnunbutapenut
Reviewed in the United States on September 27, 2020
2004 Chevy monte carlo ss dale jr car. Hooked right up much better than cutting and splicing the fronts. This is a complete abs wiring harness for the REAR two wheels.
Bill
Reviewed in the United States on December 16, 2020
Fixed the abs and skid control errors. no way to get the plugs to secure the harness though. Luckily I had some large tie straps to use.
Willie b.
Reviewed in the United States on July 17, 2019
It works very well
carl r haase
Reviewed in the United States on October 27, 2018
Plug and play
RoyHobbs
Reviewed in the United States on November 10, 2017
Installed on a 2005 Pontiac Grand Prix Base 3.8L V6. Kept having trouble with ABS/Traction Control . This is apparently a common problem on all GM W-Bodies. This harness is the correct length. Easy to install if you remove the attaching clips before installation, there are too many tight spots to get through for the attaching clip clearance. Make it easy on yourself, tape them back on after install, just mark their placement and orientation on the harness(Might want to tape the old clips back on before removing the new ones for a comparison). Compare the the old and new to make sure you have the same length side going to the same sensor as the old harness, other wise you'll get it in and find out one side is too short...it is that tight of a fit. Took me about an 2 hours to install because I fought with the attaching clips for awhile before deciding to remove them. Tape them back on with electrical tape after installation. You will have to cut the center rubber bushing where the harness Y's to the RT and LT side of the vehicle, make a clean straight cut and put it back in place after install...it's basically a rubber grommet that keeps the wires from rubbing on the frame. Some descriptions for this AC Delco part call it a trailer brake harness, however it is the correct harness for the ABS System. Fixed the problem....done.
Antonio Jacome
Reviewed in the United States on January 19, 2017
This harness is for the 1997-2003 Grand Prix. It has perfect OEM fitments. The only criticisms are that you have to re-use the old rear sub-frame rubber grommet which needs to be cut out of the old harness and the wire gauge is a little thinner. Other than that excellent replacement!
mike brinkman
Reviewed in the United States on March 12, 2016
Not really sure what this is for did not fit my 04 grand prix.
Recommended Products
$9.99
$ 4 .99 $4.99