Your cart is empty.
Your cart is empty.What will you get? 1x Nema 17 stepper motor with integrated wire length 500mm/19.6inch, 4-pin, work for 3d printer Prus i3 MK3 MK3S MK3S+ Y axis or CNC machine.
Jake
Reviewed in the United States on September 20, 2024
I didn’t think replacing the extruder stepper would help my problem with filament slipping. A lot of advice online suggested that the bondtech gears wouldn’t wear out either.But, I installed this along with a new pair of gears and I’ve had no issues and great prints ever since. It doesn’t get nearly as hot as my original Prusa motor did. It’s not loud. Everything fit perfectly and the wire was a good length.I would absolutely buy this brand again for other stepper replacements.
Mark
Reviewed in the United States on August 31, 2024
Have used 2 complete sets FYSETC motors before and have not have any issues with them. The cables lengths are exactly the same as Prusa MK3 motors and has the same connector making them a great drop in replacement or 1:1 clone. But the Z motors lead screws are bent this time. I would suggest checking them and making sure they are straight. With the motor stationary and the lead screw spinning, it should not wobble at the end of the lead screw.
Terry Morris
Reviewed in the United States on May 10, 2024
FYSETC to the rescue again. Same printer as my original review below but this time I needed a Y axis motor. Got it installed today (about 10 minutes) and I am printing again.Original review:Bought a used MK3S on facebook marketplace but it had an extrusion issue, I worked for a week trying to figure it out, was thinking the driver was weak as it would skip but was not as strong a click as my other machine when it skips, my other machine makes a very noticeable 'click' when the extruder skips and this machine made tiny 'tick' sounds. Well, the board is like $150 so I figured I would try the motor first and it turns out that was the issue.Perfect fit, wires are axactly the same length and was easy to replace and a lot less expensive than an original.
Tobashadow
Reviewed in the United States on November 3, 2024
Worked perfectly on a MK3s to replace the Y motor that locked up from over a thousand hour of use.
Riskable
Reviewed in the United States on November 10, 2024
Drop in replacement: They work exactly as they're supposed to 👍
Customer
Reviewed in the United States on April 11, 2024
Identical to the OEM and works perfect. All connections line up and plug in fine.
Timothy S. Reasoner
Reviewed in the United States on December 30, 2023
I made the mistake of thinking about only OEM parts. Ordered a new extruder motor from the manufacture. It takes a few weeks to get the parts from Prusa. Saw this on Amazon a day after my credit card was charged. Ordered it and had it installed in just a few days. Works perfect!
Mac TheTrite
Reviewed in the United States on November 4, 2023
Just what the headline says. This is a perfect replacement part for the Prusa I3 MK3S+ with the E3D hot end. It bolted right in and worked perfectly. I didn't have to adjust anything or make any changes or modifications. It even has the correct plug end already on the wire bundle.
Recommended Products
$46.10
$ 21 .99 $21.99
$22.59
$ 10 .99 $10.99