Your cart is empty.
Your cart is empty.Telemecanique Sensors FSG2J24CP 40-60 PSI Pumptrol Water Pressure Switch, Grey Cover
CLLARK1
Reviewed in the United States on September 28, 2024
Quality pressure switch. Don't go cheap on your pressure switch. Square D quality gives you the piece of mind that you will get years of service out of your switch.
twosixty
Reviewed in the United States on August 7, 2024
Worked as advertised.
Rough Road
Reviewed in the United States on August 27, 2024
There are so many cheaper versions out there and just like most of us, I'm always looking for a deal. I got the cheaper ones and they are junk! This one and Named Brand is really the only one you are gonna want. Besides it's what the pros use for a much better price!
jrf
Reviewed in the United States on June 25, 2024
Replaced my old unit without issue,
Dennis Stone
Reviewed in the United States on May 30, 2024
Good water pressure Switch. Works. Don't know about Longevity I just installed it.
layed_back
Reviewed in the United States on October 4, 2024
This pressure switch installed well and checking pressure settings , it was truly 60 psi off and 40 psi on.Factory preset was right on the money. Good quality made in Mexico. Would buy again.This switch replaced a new Merrill unit (Chinese) which I had just purchased and was junk - could not adjustand returned to vendor.
Carlos
Reviewed in the United States on October 30, 2024
Good quality
Liz
Reviewed in the United States on July 13, 2022
I replaced an existing switch that had been original to my parent's house (20+ years). It was still working but getting unreliable mostly because it was short cycling due to pressure tank bladder failing (also original to the house). I ordered this 40/60 unit as a guess b/c the labeling and model number on the old one was essentially gone. I installed the new unit and appeared to work fine. First time I've worked on well components. As a suggestion to anybody doing this, check your pressure tank and the pressure gauge (I replaced that too) to ensure the cut in/out pressures are correct and everything else is working properly.I have noticed that since installing it, the contacts already have some wear on them.The one minor issue is the instruction don't indicate what factory settings are for cut in/out pressures. I can only assume that they're are 40/60 for this unit. The cut out seemed to be slightly higher than 60.
Recommended Products
$44.98
$ 22 .99 $22.99