Your cart is empty.
Your cart is empty.Product Description
Customer
Reviewed in the United States on January 12, 2025
I use it for my batteries and the winch works great.worth every penny
Melissa Schurman
Reviewed in the United States on July 7, 2024
Very impressed with the quality! These work great.
leroy
Reviewed in the United States on December 11, 2024
Worked great to replace the old damaged plug on my plug in jumper cables on my service truck
David T.
Reviewed in the United States on October 20, 2024
After installing the winch, placed the quick disconnects, attempted to plug the two ends together and it was very difficult to connect and disconnect the ends. Would not buy again.
SLT
Reviewed in the United States on October 13, 2024
The people that do not understand that the 'terminal' needs to be installed so the tension tab goes down to 'merry' the two ends together, really need to update their reviews. Some people need generic instructions i guess. This is a very nice product, however, it would be nice to include a few 6-8 guage lugs for versatility.
Matthew Buechel
Reviewed in the United States on June 2, 2022
Great connectors. Easy to crimp. Work well. The rubber covers suck. I prefer the plastic covers instead
Shawn
Reviewed in the United States on March 30, 2022
This is for the Red Frienda 3 pack of 175a connectors and contains rubber covers. The red plastic housings are labeled JNCK Power Products SJ 175A-600V. The metal connectors will snugly fit 1/0 welding cable even though description says 2-4ga. It's a bit big, I doubled over the factory 6ga wire on the device and used some 6 ga also doubled over and crimped in there which worked ok. These are way overkill for my 12v 85A load, but that's ok bigger is better. Yes I know the device is using too small of wire...I cut the wires about 12" and installed this plug there. MY wiring will be much larger.They went together pretty well and crimped down with a heavy duty Hydraulic crimper die size of 35. You WILL need something similar. Some say solder, but that can also cause problems with creating a breaking point of the wire and cold solder joints. I also recommend using Dielectric Grease on the contacts to maintain minimal corrosion for years.If your cable is twin, make sure to crimp so both blades are facing the same direction so the wire will lay in connector nice and flat. As well as make sure the flat sides of crimp are sideways or on the same plane as the flat of metal connector to fit better in the connector.
MD101
Reviewed in the United States on November 15, 2022
These are as expected and nice quality as far as I can see. I have no other experience with these so I can't compare them.As these were the first time I installed these, it took just a bit to figure out which way they go in. Once I figured that out, I pushed them in till it clicked and seated well.I need to buy more of these and update the rest of my equipment.Have fun!
Recommended Products