Your cart is empty.
Your cart is empty.Product Description
Transmits heat continuously to keep engine oil as a thin fluid, giving you instant lubrication when starting your engine
Properly sized and installed Facon Heater Pads provide consistent & efficient protection as the first signs of freezing winter weather approach
Specifications:
- Model# CW-B45
- Brand: Facon
- Pad size (Inch): 4" x 5"
- Pad thickness: 1.80MM
- Volts: 120Volts AC
- Power: 50 Watts
- Electric Current: 0.45A
- Lead Wire Lengh: 72''
- Built-in thermostat is set to turn off at 190°F ( + - 10 degrees)
- Plug type: 2-Prong Power Cord, No ground (type E)
- 3M Self Adhesive easy installation to any metal surface
- 1 x Weatherproof silicone sealer included in the package
Battery heater pad
- Size(Inch): 4’’ x 5’’
- Designed to be applied directly to the source, resulting in direct heat transfer.
2-Prong power cord with 3M Self Adhesive
- Plug type: 120 Volt, 50Watts, 2-Prong Power Cord, No ground (type E).
- Length: 72-inch (183cm)
- 3M Self Adhesive easy installation to any metal surface.
Thermostat Controlled
- Plug it into 120V AC Power 10 or 15 minutes prior to start up for perfect engine oil temperature, device heats the oil quickly for those cold start mornings.
- Built-in Thermostat is set to Turn Itself off at 190°F ( + - 10 degrees).
- Unplug before driving away
RR
Reviewed in the United States on February 6, 2025
QUITE GOOD; HOLD THE PAD AGAINST THE VALVE COVER ON AN OLD 2.2L 1991 HONDAACCORD, AND IN COLDER WEATHER IT MAKES SOME GOOD DIFFERENCE IN THE INITIALWARM-UP OF THE ENGINE, ALLOWING IT TO START RUNNING MORE SLOWLY MUCH MOREQUICKLY. IT IS ENOUGH TO GENTLY WARM THE HEAD AND SOME OF THE OIL, AND ALLOWSTHE ENGINE TO IDLE SMOOTHLY AFTER STARTING, IN A MUCH SHORTER TIME. I DO NOT USETHE ADHESIVE, AS I MUST UNPLUG IT AND DRIVE AWAY, SO i SIMPLY PRESS THE PAD TO THECOVER. I USE IT ALL NIGHT, TO GET ENOUGH GENTLE HEATING FOR THE START.
Somebody
Reviewed in the United States on January 23, 2025
I purchased this product ahead of a super-deep-freeze (below 0°F several nights). I have not used this product yet and probably won't until December 2025. It's certainly affordable.
michael p
Reviewed in the United States on January 17, 2025
I have these on two small tanks. I've checked the temp a few times when the outside temps were in the teens and my tanks were consistently in the forty to forty seven degree (ferinheit) range. Good enough for me.
JElliott
Reviewed in the United States on January 13, 2025
Product on line says it has an auto shut off at 190° F.Instruction guide says 68° F. 68 degrees is worthless for heating up 5 quarts of oil in single digits.
Jean-Marc Tremblay
Reviewed in Canada on September 28, 2024
Pas encore installé mais tout est la
dangina
Reviewed in Canada on May 3, 2023
preventing my waterer from freezing
Barry
Reviewed in Canada on February 14, 2023
Installed easy on the oil pan of my truck. Engine warms up faster when cold out.
Customer
Reviewed in Canada on February 10, 2023
Bonne emballage, vient avec tube de silicone et bonne explication de montage.
D. Mei
Reviewed in the United States on December 9, 2022
I just received this and did some testing on it. It arrived in good shape and is a new item. Tube of silicone is present and everything looks right.I will raise or lower the ratings based on what I find when I actually install it.It draws 44 watts of power so it's pretty close to spec. I was looking for a relatively low powered pad and wanted to make sure it wasn't way out of spec on the high side.The pad gets up to about 180 deg in free air. Once it's installed on something that can draw heat out of it, it will not get as hot.
Pekioguy
Reviewed in Canada on November 15, 2022
Misleading. Advertised at 150 watt heat pad but actual product is rated at only 50 watt.
Ford Sparkee
Reviewed in the United States on January 19, 2022
Holy Whaaaa this bugger is the whip! Michigan winters can get a lil cold and my IR T30 air compressor gets really grumpy when it does. Yes, IR makes a block heater but ding dang they're pricey. Then I saw this guy and presto! Problem solved. It’s the perfect size to stick to the side of the two stage cast iron lung. Starts much easier. Now i just gotta set up something so i can turn in on/off thru WiFi. Hmmmm.??
Matt
Reviewed in the United States on January 20, 2021
Easy install and seems to adhere well. I installed this on my ford 860. I warmed it up for about 10 seconds first to get it to bend to the side of my oil pan and it stuck great. I used a block of wood to hold it until it fully bonded and now works great. Only used it a couple times but it gets very hot quick so be careful.
Kris
Reviewed in the United States on January 12, 2021
Contrary to the intended use, this is on an external tankless water heater and not my truck. I use it to keep the water heater from freezing over and busting when the temps drop. Along with a solid wrap of fiberglass insulation, I'm very pleased with this product and I'd happily recommend it for whatever use.
Recommended Products