Your cart is empty.
Your cart is empty.
E-Z Lok manufactures threaded inserts for metal, plastic, and wood. The company is headquartered in Gardena, CA.
Scott Hanson
Reviewed in the United States on August 24, 2023
Saved the cylinder head cover on my motorcyle
David
Reviewed in the United States on December 19, 2023
Just what I needed
Eric Hatter
Reviewed in the United States on December 11, 2023
A volt snapped off when removing the valve cover. None of the other extraction methods worked so I had to finish drilling it out and put a helicoil in. The tap is tapered and I could not get the threads deep enough on the bottom half so I had to cut a helicoil in half (wish they came with a variety of depths). Is it the best? I don't know, but I took it slow and it worked for me. Tap handle not included.
Bessnbill26
Reviewed in the United States on January 12, 2023
Arrived in one day. Top notch kit with sharp bit and tap! It has quality inserts as well. Did the job perfectly.
shawn bkackwell
Reviewed in the United States on December 7, 2022
After striping the rear stud for the valve cover in the cylinder head of my BMW S52 engine, I used this tool to drill and insert. It is the perfect thread pitch and is easy to use. No leaks, hold to torque spec, and holds great!
Javier Garcia
Reviewed in the United States on February 6, 2021
Didn’t last 1 minutes poor quality
David R Murison
Reviewed in the United States on August 2, 2019
I used this to repair 3 pulled out studs on the rocker arms of a bmw m52. kit worked good. a little grease helped the insert slide in(would not install dry).
Jonathan D. Howell
Reviewed in the United States on March 26, 2016
Fantastic thread repair kit. It has everything needed to repair stripped threads.
Recommended Products
