Your cart is empty.
Your cart is empty.
Product name:Feed Drive Roller Exit Drive Roller Tire Rubber
Compatible with Fujitsu fi-6110 N1800 S1500M S1500 S510M S510 S500M S500 fi-5110EOX fi-5110C fi-5110 fi-5110EOXM fi-5110EOX2
OEM code / Part NO:PA03586-K983 PA03586-K984 PA03360-Y101 PA03360-Y115
Condition: JAPAN NEW
RH
Reviewed in the United States on August 23, 2024
Although it was time consuming to open my Fujitsu S510, it now works perfectly. Expect to spend a few hours on taking down the scanner and putting it back together. I searched youtube for something like "fujitsu scanner roller replacement" to find out how. Take your time. I am somewhat mechanically inclined, so for me, it was well worth it to have my scanner working again. I just scanned something after a month or so, and it works like new.
Chuck Y.
Reviewed in the United States on June 19, 2024
work as intended
pbd, california
Reviewed in the United States on December 25, 2023
look at youtube on how to install.
Deekoi
Reviewed in the United States on July 5, 2022
I purchased the roller replacement for the scan snap S510. The tolerance for the rubber to fit in the rod was far too small. If didn't destroy one of the rubber replacements I would have returned it. Eventually, I managed to install it on one set of rollers and ended up using electrical tape for the other set. Also, this if you're not comfortable disassembling most of the unit, you should pass on this project.
Lesik661
Reviewed in the United States on February 16, 2022
Item is a good quality, but very hard to slide on. Had to use scissors as a clamp and use my weight to push it down. It fixed the issue I had with my printer.
CuriousGeorge
Reviewed in the United States on June 10, 2020
Did not work well with fi-5110EOXAs you must cut it, it leaves a gap too large to pull together to get it over the roller bar.
aquaholik
Reviewed in the United States on December 16, 2020
Replace the sticky roller on my trusty S510. Disassembling is a pain. Youtube some video of it. The roller is great since it's fairly soft so you can add a little of oil and it will slide on to the shaft with a small amount of effort. Going to buy another set for my backup S510.
JM
Reviewed in Singapore on October 24, 2020
Purchased those rubber rollers to replace the old ones of the Scansnap S1500 : feed rollers and eject rollers .They fit well .I think it is important to know that the replacement of the roller is a tedious work as you need to dismantle a lot of part of the scanner especially for the feed rollers , I did it with the help of the video found on Youtube which was a great help .
Michael
Reviewed in the United States on September 24, 2018
The rolls are cut along one edge and onc inserted over the entry and exit rolles of the FUjitsu S1500 there is a 3mm gap on each of the rollers. This causes the paper to be pulled every so slightly unevenbly and this causes the scan results to be unusable.
Recommended Products
