Your cart is empty.
Your cart is empty.
ETEKJOY 100PCS 13.56MHz RFID Key Fob Proximity IC Card ISO14443A Token Tag for Electronic Smart Door Lock, Compatible with MIFARE Classic 1K Card M1, Read Only
Note: These are 13.56MHz key fobs (tags). If you want to register them to your lock system, please ensure that your system uses the same frequency 13.56MHz. Incompatible with other frequencies like 125kHz.
Read only. Not re-writable. Each key fob is already pre-programmed. You cannot re-program them by a card writer.
Compatible with MIFARE Classic 1K Card (M1 Card). If your lock uses M1 card, these key fobs work for your lock too.
Suitable for 13.56MHz RFID proximity access control system and ID management system. For example, register them to your RFID door lock as new keys if applicable.
Approx. Fob Size: 1.58*1.26*0.18 inch. Casing Material: ABS Plastic.
Package includes 100 Pieces.
Scott
Reviewed in the United States on September 8, 2024
It is compatible with TTLock and SMONET door lock.
MOHAMMED RAHIM
Reviewed in the United Arab Emirates on June 30, 2024
Very good performance
New Hope Baptist Church
Reviewed in the United States on April 10, 2024
Bought these and they work like a charm with Unifi Access. It's possible other reviewers just received a bad batch, but my batch worked right out of the package.
Rebecca Zehring
Reviewed in the United States on May 6, 2023
Forget paying $20 for 4 from the manufacturer. These bad boys work just as good n the price makes it so worth it!
Bryan Rooney
Reviewed in the United States on August 8, 2022
if you have unify/ubiquiti systems these work fine for it. thats what i used them for and they're so much cheaper so well worth it
Jeff
Reviewed in Canada on August 29, 2022
Vendor was very friendly when answering questions I had about the product. Keys work as expected.
LarzWalker
Reviewed in the United States on June 4, 2022
These are just klinky sounding on your Keychain compared to the others I've used. And I've had a few more defects than normal.The problem with any of the fobs that are defective is that they don't just not work. They disable the frigging lockset so you have to pull the batteries to reset it. Even master keys no longer work until you pull the batteries.I've been marking the bad ones and when I have time I'm going to disassemble and test to try and identify the common denominator that's the failure point.
Daniel M. Ribar
Reviewed in the United States on April 19, 2022
Bought for use with UniFi door access. Worked perfectly and 100% so far.
Generic
Reviewed in the United States on December 10, 2021
Works well on our lock. Great price. Haven't found a bad one yet
Tek
Reviewed in the United States on January 22, 2021
I have 4 Schlage "CONTROL" series locks that work with MIFARE CLASSIC and DESFIRE credentials. They support both 125khz and 13.56 MHZ bands. These tags DO NOT work with this system. That may be due to the tags not being encrypted, since they are read-only. That is a huge security violation and makes sniffers and cloners VERY EASY to capture the tag's serial number as it is being presented. If you're using these tags for door locks, you seriously need to re-consider your lock and tag choice, and get an encrypted one.Second, the physical tags are very cheaply made, and they're not glued or sealed. it is far too easy to break the cheap, flimsy plastic, and the cover over the chip and antenna pops out easily. It really wouldn't be that much more difficult to seal or glue them, especially considering that the chip is sitting on epoxy already and it would be just as easy to squirt a little more epooxy in there to hold the cover on.I don't understand how these have a 100% perfect 5-star rating. They're terrible! Not encrypted, cheaply made, fall apart easily, and NOT compatible with the MIFARE CLASSIC 1k system that they claim to be. I am giving 1 star mostly because of the cheap construction, but also because of the incompatibility.
Recommended Products
$74.97
$ 29 .99 $29.99
$119.00
$ 47 .99 $47.99