Your cart is empty.
Your cart is empty. MOUNTING AND INSTALLATION:
Step 1: The pad heater must be installed on a flat, uniform surface with 100% of the heater surface in contact with the object being heated.
Step 2: If intended application area is painted, paint must be removed prior to installation. The temperatures associated with heater operation can cause paint to crack causing the heater to delaminate from applied surface.
Step 3: To obtain adhesion, the bonding surfaces must be clean and dry. Some recommended surface cleaning solvents are isopropyl alcohol or heptane. The solvent must be non-oil based.
Step 4: Plug the pad heater in for a short time (about 5 seconds) to warm the adhesive.
Step 5: Slowly remove the cover on the heater to expose the pressure sensitive adhesive. Orient the heater as desired and apply it to the selected surface. Apply pressure to the entire heater with a roller to eliminate potential air gaps.
Step 6: Once applied to desired surface, energize heater for a short time (about 30 seconds). De-energize heater and again apply pressure.
Step7: Use the wire ties provided to secure the power cord in a manner that isolates the cord from hot surfaces and provides strain relief.
WARNING ::::::: Personal Injury: Avoid touching the heater while it is energized
John Sellen
Reviewed in the United States on December 25, 2024
The package made it to my home. The best thing about this order. I prepared the surface above and beyond. Nothing worked. It never glued.
mike
Reviewed in the United States on April 4, 2024
Product works as far as a heating element, cable is nice and durable and is a 3 prong (ground) and bonded well to the element. However the adhesive material is awful. Cleaned and prepped aluminum oil pan per instructions and pre heated element (3-5 seconds) and would not adhere to a bare aluminum surface. Product needs to be reworked. I would not recommend until they come up with a fix solution for a better adhesive method.
gary
Reviewed in the United States on July 23, 2023
Keeps my dsl tractor ready to go
Genuine reviewer
Reviewed in the United States on June 24, 2023
Works well use gasket maker around the edge when installing to add durability
Greg B.
Reviewed in the United States on December 6, 2022
This sticks good to a cleaned (sanded and oil free) oil pan, heats fast but you will have to monitor or set up a timer switch. Works great with the SYLVANIA SMART Bluetooth Outlet.I now have 2 of them one for a truck that sits out on below 0 degree days helps a lot, and the other is on a airplane to preheat before I get there.I will buy more.
SAM
Reviewed in the United States on November 19, 2022
Heats like says, Easley installed. Added timer to turn on and off.
Todd Berube
Reviewed in the United States on May 23, 2021
Keep my fuel from jelling. Just what i needed
T. ARHEIT
Reviewed in the United States on May 29, 2020
They do stick quite well to clean surfaces. It's easy in engine compartments and even new batteries to have a thin coating of oil and dirt on them that will cause problems with most adhesives so it must be clean. If in doubt it can be good to mechanicaly secure the heating pad.They are simple devices and the dozen or so I've used all seem to work quite well. Do note that they do not have a thermostat built-in and can get quite hot when not attached to a battery or other 'heat sink'. Works as well as more expensive brands we've tried (some that don't even have the adhesive)
Recommended Products
$107.00
$ 50 .99 $50.99