Your cart is empty.
Your cart is empty.
DIN Rail Mount DB25 Interface Module.
Male and Female DB25 connectors.
Screw terminal block.
Din rail mountable - for width 35 / 32 / 15mm rails.
Din mount case can be taken apart for panel mount use.
High quality PCB carrier.
FR-4 fiber glass PCB.
External dimensions: 87 x 80 x 43mm(W x L x H).
PCB dimensions: 72 x 77.35mm(W x L).
100% new, never used.
Terminal block specifications:
Pitch - 3.81mm.
Rated voltage - 150V.
Rated current - 10A.
Wire range - 26-16AWG.
Strip length - 5mm.
Screws - M2,steel,Cr3+ Zn plated.
Torque - 0.2Nm (1.7Lb-In.).
Pin header and Cage - Brass.
MichaelMSG
Reviewed in the United States on April 19, 2020
Exactly how expected will buy again Great breakout board.
Bob Saget
Reviewed in the United States on September 24, 2019
Din rail mount plus both genders of dsub connectors, not much else to say.
Customer
Reviewed in the United States on August 5, 2019
This is a Great Product. It allowed me a combination of either using a male or a female cable to the product I was attaching to the breakout board. Easy installation, mounted to the din rail with no issues and wired my flying leads to the connector. Built an 8 axis system test fixture with this product. Thanks
Kristin
Reviewed in the United States on December 4, 2019
Good product that worked as expected
Darren
Reviewed in the United States on December 31, 2019
Sturdy, well built, quality components. Works exactly how I needed it to.
Andres
Reviewed in the United States on December 14, 2019
This is a good product. I would not use it for tough industrial environments, but it is great for a lab or protected environments. The terminal block connectors are smaller than expected. An AWG20 ferrule barely fits in there, but once inside and tightened, it makes a solid connection. The dual male/female db connector is very convenient. It is not the mk ost efficient breakout board out there, but for the price you get a lot.
Peter
Reviewed in the United States on December 12, 2019
Freaking love it. Simple and mounts on din rail with other adapters like this. I've been debugging a wonky RS485 connection that goes through RJ45, DB25, and DB9. Sounds a little too-perfect, but all these adapters helped a ton to measure levels and using a protocol analyzer on the pins going in and out of converters
PKD
Reviewed in the United States on June 7, 2016
Solid product at a good price. Arrived very quickly. Packing/shipping was way above my expectations.
Recommended Products
$22.99
$ 11 .99 $11.99
$40.00
$ 19 .99 $19.99