Shopping Cart

Your cart is empty.

Your cart is empty.

Electrolux 154844301 Motor Kit

Free shipping on orders over $29.99

$79.95

$ 34 .99 $34.99

In Stock

About this item

  • Item Weight: 0.02 lb
  • Country of Origin: United States
  • Brand name: Electrolux
  • Item Dimensions: 10.0"L x 8.0"W x 8.0"H


This is an authorized aftermarket product. Fits with various Electrolux Brand models. It has a OEM Part # 154844301.


Jarrett B.
Reviewed in the United States on March 11, 2025
Works like a charm. Dishwasher was incredibly loud and didn't clean dishes very well. Quick and easy swap of this part and runs great! Cleans the dishes and I can't hear it in the living room.
Anthony B.
Reviewed in the United States on February 9, 2025
Working good so far.
Mike M
Reviewed in the United States on February 6, 2025
OEM part as advertised. Quick and easy swap. Mine came with new seals which I’ve read on other reviews that the part was missing. Maybe a slip up at the manufacture but mine was supplied.
Magda Gaul
Reviewed in the United States on February 24, 2024
It was easy to install
Ohiobuyer
Reviewed in the United States on December 17, 2024
I replaced an existing pump today with this one that I ordered. The new pump is quite noisy. I question whether this is an official Electrolux part or a cheap knock off. I’ll be interested to see how long this last.
Alex P.
Reviewed in the United States on August 7, 2023
After some research I found this kit works perfectly on my Frigidaire washer. It was $40 cheaper than the one from the Frigidaire and had one day shipping so I went with it. The swap was quick and simple. There was A LOT of noise through the first half of the wash cycle but it resolved on its own and has been functioning perfectly since.
topseyturv50
Reviewed in the United States on December 11, 2023
I installed this on a old Frigidair gallexy dishwasher and it fixed the problems
steve
Reviewed in the United States on October 20, 2023
Pulled dishwasher out from counter, tipped onto its back, remove two screws from retaining clip, pull out retaining clip, disconnect wiring harness, wiggle pump out of housing, push in new pump (applied a little dish soap to o-ring to make easier to slide in), push in retaining clip, put in the two screws, connect wiring, tip back upright, slide back under countertop.Dishwasher works great now.
VICRIC
Reviewed in Mexico on October 19, 2022
Refacción original para un servicio sin problema
Recommended Products