Your cart is empty.
Your cart is empty.4.6 out of 5 stars
- #35,366 in Automotive (See Top 100 in Automotive)
- #3 in RV Exterior Ladders
Product Description
Starlink V3 Pole Set-1.0
STARLINK GEN3 AND GEN2
10FT | RV Ladder Pole | 10FT |
Gen3 Pipe Adapter | Adapter | Gen 2 Adapter |
| | RV Ladder Mount | |
| | Ladder Rails Size | Fit for 1.0 |
10FT | RV Ladder Pole | 10FT |
Gen3 Pipe Adapter | Adapter | Gen 2 Adapter |
| | RV Ladder Mount | |
| | Ladder Rails Size | Fit for 1.5 |
- Starlink V2 Pole Set-1.0
- Starlink V2 Pole Set-1.5
Mike
Reviewed in the United States on February 27, 2025
This works great on my motorhome. I like that it securely holds my Starlink v3 antenna up out of reach of kicking on accident or easy pilfering. It is very secure. First time use was the last week of the season at Convict Lake in the eastern sierras. One night the wind was gusting 70mph, the motorhome was rocking and rolling, and the antenna stayed put. It compresses short enough to fit in my bay. As a matter of comparison, this pole is much sturdier than a telescopic flat pole. I would not use a flagpole to hold my expensive antenna. Even in 35mph sustained winds with gusts to 70, Starlink remained fully functional.
Keith Schneider
Reviewed in the United States on September 23, 2024
Brackets are a tad clumsy to install as you juggle the screws/nuts (all stainless steel) but once installed, nice and solid! They fit my 1 inch RV ladder perfectly. My ladder is not straight up/down (either sideways or front/back). So you need to assess your install so you can best keep your pole reasonably vertical (advice, not the products issue). The lower cup for the bottom of the pole is big for the 10 foot pole but apparently this allows it to use other poles of greater length and diameter. I cut a 2 inch piece of PVC plumbing pipe with a 2 inch ID and it fit decently in the CUP and also provides improved tightening of the screws when the pole drops into the cup. The screws tighten against the PVC, gripping the pole evenly, not potentially denting the aluminum pole. With this setup, my pole is rigid and no sway. Either way, it works well and secure. The 10 foot pole I got, all sections but one work/slide very smoothly and and the one section seems a bit tight/rough to work but still seems secure. The GEN3 bracket is nice die cast metal but I made a mistake and needed the adapter for the Starlink MINI. Fortunately, the seller is getting the MINI adapter into stock and offered to exchange my GEN3 for a MINI for free - TOTALLY SAVES THE DAY!!! I got the brackets and the pole installed and it works well. I chose this model/brand for the brackets first (not plastic) and adjustable and 2nd for the pole which seemed convenient being telescoping vs: multiple separate sections. After the install, the pole simply extends and slips into the brackets all in 1 minute. With the MINI adapter, my setup will meet my expectations.UPDATE: Seller delivered the StarLink MINI adapter and it is clean and solid metal and fits the starlink and pole perfectly - Very Nice - Totally Pleased!
D. Bouse
Reviewed in the United States on September 20, 2024
It’s nice to buy something that actually works like it should, and this holder does just that! Metal and solid, there was just a tiny bit of wiggle on the front edge where it snaps into the starlink series 3, so I put one strip of electrical tape across this bracket and it snapped in very snug! The solid aluminum brackets are very sturdy and hold the great telescoping pole excellent, I just twist the pole before installing it in the brackets so it wraps the cable around it, holding it in place nicely. Then I put the router and power supply in the “basement” of my coach where I can easily plug it into 110 volts, setup works PERFECTLY, and EASY!! No need to run the cable inside the coach for a great fast signal. Thanks for a great product!
Richard R
Reviewed in the United States on August 30, 2024
It installed in 15 minutes. Works perfect. Fits my round, 1" diameter ladder railing perfectly. No more ladder climbing to use my Starlink Gen3 Antenna. The adapter that slides into the antenna is quality metal and while it is very secure when in place, it's also easy to remove when transporting our RV to a new location. It truly is a 3 minute install/uninstall utilizing the telescoping pole with no fear of losing any parts as there are no parts to lose because it telescopes. Love this thing!
Oskar
Reviewed in the United States on June 11, 2024
I recently purchased this product on Amazon to use with my Starlink kit on my RV, and I couldn't be happier with my decision. This product exceeded my expectations in every way.Quality: The build quality is outstanding. It feels durable and well-made, which gives me confidence that it will withstand the rigors of RV travel.Design: The design is sleek and modern, fitting perfectly with the setup in my RV. It is evident that a lot of thought went into the aesthetics, making it a stylish addition to my mobile living space.Functionality: Every feature works flawlessly. From the ease of use to the intuitive controls, everything about this product is user-friendly. It performs its functions efficiently and effectively, making setting up my Starlink kit a breeze.Compatibility: This product is the perfect solution for my Starlink kit. It integrates seamlessly and has enhanced my overall experience, providing reliable connectivity on the go.Value for Money: Considering the high quality and all the features packed into this product, it is definitely worth the price. I feel like I got great value for my money.Overall Experience: I am thoroughly impressed with this product. It has met all my needs and even surpassed some of my expectations. I highly recommend it to anyone looking for a reliable, well-designed, and functional solution for their Starlink kit on an RV.Five stars all the way!
Lucas K.
Reviewed in the United States on November 8, 2024
I’ve had my Starlink up now for a few days, and I love it. The ladder attachments and pole adapters looked like plastic in the pictures, but they are metal that’s been coated with a rust proof material smooth to the touch. The pole mount gives my Starlink extremely high clearance with great reception. The pole adapter itself is of much sturdier quality than Starlink’s own on their website. It was a pricey purchase, but I highly recommend those particular productThat being said, you can over tighten the pole arms, so just gently twist them until they are tight enough. Otherwise you will have to continue twisting it to get it locked into place. The upper arm like attachment holds the pole in place and makes taking the whole thing down extremely easy. Unfortunately, that means that the pole does sway a little bit in windy conditions, causing some clanking from outside the camper. This is a relatively easy fix though, as you can just bungee cord it to the ladder itself to prevent the pole from swaying causing noises.
Recommended Products
$182.95
$ 77 .99 $77.99
$119.95
$ 54 .99 $54.99
$21.77
$ 10 .99 $10.99
$309.95
$ 99 .00 $99.00
$91.26
$ 41 .99 $41.99