Your cart is empty.
Your cart is empty.Drill America DWCT series end mill is designed to machine most materials of medium hardness such as steel, brass, bronze and iron. The large core diameter provides rigidity and reduces deflection while the cutting geometry allows for rapid stock removal. It can be used for general-purpose milling including profiling, slotting, keyways and pockets. It will also plunge cut.
jim strickland
Reviewed in the United States on March 9, 2025
The bit was of good quality
Casey
Reviewed in the United States on September 21, 2024
Great High speed steel endmill. Great cost. Fast shipping.
RichD
Reviewed in the United States on February 23, 2024
Not exactly the intended purpose, but I needed to countersink a couple holes on an angle. Only had a drill press with a 1/2" chuck. It did the job and I can complete my project.
Jason Goodale
Reviewed in the United States on November 20, 2024
18mm end mill is the size needed to mill a slot for a single coil guitar pickup. I’m about to pull apart $1400 evh star, mount it on a mill at work and start cutting! Haha wish me luck🙏
R. Redd
Reviewed in the United States on December 11, 2023
As title says works great. Does what it supposed to do.
Bryan
Reviewed in the United States on November 16, 2023
Item was listed as "2 flute". As you can clearly see by the photo, this end mill is a 5 flute. This is not a problem for my application but it may be for yours. Otherwise satisfactory for the price point.
Fixerflyer
Reviewed in the United States on October 24, 2023
Bits are great but make sure you are perpendicular to a flat surface. Carbide does not like irregular surfaces or off angle drilling.
Pepe
Reviewed in Mexico on September 17, 2020
Llego en tiempo y forma. Lo devolvi ya que me esquivoque yo en lo que lo iba a utilizar. Sin poblema me reintegraron lo pagado.
Cliente de
Reviewed in Mexico on February 20, 2017
La imagen no muestra el cortador que debe de ser.A pesar de eso, es un buen cortador.Quede insatisfecho.
Customer
Reviewed in Canada on December 20, 2017
good thanks
RAKC
Reviewed in the United States on July 30, 2015
Works as an end mill should but wasnt too pleased with how brittle the bit is. Chipped leading edges of 2 of the flutes simply cutting into a piece of 6061 aluminum. Harder metals I would have expected this from a cheap bit, but this is 6000 series aluminum, I can trim a rough edge with a box cutter.Get what you pay for but I had expected proper treatment of the bit, not that hard and if I had known these were THAT brittle, I would have thrown it in the oven for a few minutes first.
Recommended Products
