Your cart is empty.
Your cart is empty.High quality double sided through-hole plated PCBs in various sizes and quantity. All PCBs are 1.6mm thick.
Maisie
Reviewed in the United States on March 13, 2025
They seem to be of good quality. I had to do some abusive soldering, unsoldering and resoldering and there is no sign of damage.
Jhon López Valencia
Reviewed in the United States on September 7, 2024
Excelente terminado, funciona correctamente
John F Hall
Reviewed in the United States on July 24, 2024
These boards worked great for my pedalboard power project. I was able to solder all components and wires to the board with no issues. Also very easy to cut to size with an exacto knife and drill standoff holes with a dremel, no problem. I will use them again in future projects.
pmgallo
Reviewed in the United States on June 28, 2024
Double sided well made.
Mind Stolen - Human rights. Stop torture.
Reviewed in the United States on June 11, 2024
These PCB prototype boards are not bad. I was able to build some serious stuff using them. They are in good hands.
Hank
Reviewed in the United States on November 18, 2023
Very well made and easy to trim to size.
Maarten Hofman
Reviewed in the United States on November 3, 2022
These protoboards are solid. The fact that they are double sided is very useful, and in most cases the solder flows well on them (they are not as good as the JLCPCB boards, but those are very hard to beat). They sometimes come attached to each other, but it turns out you can break them apart easily.
truckfan
Reviewed in the United States on October 12, 2021
You can buy similar boards in many different sizes. For what I do I like this specific size in both single- and double-sided forms. Per-board the price is decent if you buy 5 at a time and gets even better if you buy 10.Whatever size you buy, make sure that the copper pads are tin-plated. I bought some boards with copper pads and some others that appeared gold-plated but weren't, and it was a pain getting the solder to stick even after polishing them with a dremel wire wheel.These are easy to snap to smaller sizes. Use a sharp metal scribe (not an Xacto knife - they tend to take off in their own direction) and a metal ruler to scribe a deep line wherever you want to snap the board. Then lay it on a sharp edge and snap along the line. (I prefer to use pliers to bend the board because that gives a cleaner snap and is probably safer, too.)
Recommended Products
