Your cart is empty.
Your cart is empty.Product Description
Small Solderable Breadboard
They are small, so you won't end up with clumsy prototypes.
Just the right size, ideal for components (resistors, diodes, capacitors, etc.)
Small and flexible
You can combine as many of them together,
in any configuration you may need, because they are all interlocked.
Adhesive pad
These are great for very small circuits,
with adhesive pads on the back. It stays well and the connection is perfect.
Good heat resistance
Good heat resistance
very suitable for components
Insulation flame retardant
Color is also very helpful
Easy to install
Can be spliced
Firmly connected
With mounting holes
Vibrant colours
01
The mini breadboard is perfect for holding some DIY microprocessors and shields.
02
The adhesive on the back is perfect for sticking to the battery pack
03
Good heat resistance, smooth and high gloss
04
They are perfect for small circuits.
Michael Hanschke
Reviewed in the United States on February 17, 2025
Worked. A bit cheaply made, but fits the bill.
Tony
Reviewed in the United States on February 15, 2025
Excellent little bread boards. You get a lot for the money and they work great with jumper cables. They're simple and serve their purpose. The quality appears just fine and they get the job done!
MIn
Reviewed in the United States on May 3, 2024
Works well and small to fit into prototypes
a teacher
Reviewed in the United States on July 27, 2023
These mini solderless prototype circuit boards are of a very good quality.I just used three of them to build and test three four pole crystal filters.Here, the filters uses 4 crystals, two 82 kilo ohms resistors and five ceramic capacitors.The connections were reliable and the filter worked- so these circuit boards did their job!Incidently the center frequency of my filter was 32.768 kHz with a one Hz bandwidth.
Allison Morgan
Reviewed in the United States on July 20, 2023
Small and cheap
I'm a real customer
Reviewed in the United States on July 12, 2023
These are great because of the different colors. They are ideal for small Arduino micro-controller boards that can be swapped easily with jumper wires. The adhesive is practical for placing inside of boxes or other containers. Some may find these too small for handling more than 3 or 4 sensors so I would advise to use these for minimalist projects that require few sensors. But the small size again makes them ideal for the right projects!
Brendan Ford
Reviewed in the United States on October 12, 2023
Though I used these for small projects that only needed to be as big as these are, I love that these have the little slot/tab for connecting them into basically any size you would need.In my case, I had to cut the tabs off to fit these into the project boxes I had, but that was easy enough to do with a set of wire clippers.
Recommended Products