Your cart is empty.
Your cart is empty.This radiator drain petcock is a direct replacement for the original equipment plug that may have deteriorated or corroded. Made of quality materials, this petcock is engineered to strict standards for durable use over time. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Jeep Grand Wagoneer: 1991, 1993] - [Jeep J10: 1987, 1988] - [Jeep J20: 1987, 1988]
Customer
Reviewed in the United States on January 5, 2025
It’s doing exactly what it should be doing
John Stone
Reviewed in the United States on May 3, 2024
It works well but didn’t serve my intended purpose. I made a stainless compressed air tank and wanted to use this as a drain. The only problem was that it would leak at around 150 psi. Pretty sure if you are using this in your radiator then you wouldn’t experience this problem or that high of a pressure.
Andrew V
Reviewed in the United States on February 28, 2024
Went right on my compressor and now it drains like new.Five minutes and it was good to go.
shirley durham
Reviewed in the United States on January 15, 2024
Works perfect
dan60231
Reviewed in the United States on June 11, 2023
Nice part, I used some teflon tape on it just to be on the safe side.
riverguy
Reviewed in the United States on June 7, 2022
This drain cock does work, but it requires pliers to tighten it enough so it doesn't bleed air. Not a big deal on an air compressor since one doesn't have to open/close it that often, but I have several of these in service in my shop and this is the first one that won't seal tight with a finger tightening.
RacerX
Reviewed in the United States on December 30, 2022
Useful anywhere a 1/4" NPT petcock is required, commonly used as radiator drains in older cars. The body of the valve is made from solid brass and won't rust or seize. The wing on top is steel, but is plated to resist corrosion. I use these in racing engine blocks to simplify draining of coolant, which in drag race engines is usually only water, so corrosion resistance is necessary.
Dwayne
Reviewed in Canada on June 17, 2020
perfect
remote camper
Reviewed in the United States on October 3, 2020
Perfect alternative to the yellow snap plastic container vent caps that might want to be used on gas cans or where vent cap has been lost or is less secure on 7 gal and similar water containers. Durable and secure seal and the cap won’t get lost. For a new install, drilled a small guide hole in thickest part of the can to start (where the vent has been omitted) and used a reamer and small shop vac to catch shavings. Reamed just to point where threads on the petcock would catch. In my opinion, this petcock is the best way to go.Smallest part of the threads at the tip measure .52" and .54" below the hex nut with a digital caliper. In my opinion, there might be insufficient material left for a straight across conversion of old vent cap to a brass petcock in the same hole. With care though, it could be made to work with an adequate permanent sealant. This is something you do at your own risk.
talon78
Reviewed in Canada on January 12, 2019
The reason many people are reporting slow leaks is because the sealing surface is metal on metal. Designers were too cheap to install a rubber O ring or similar gasket. Too bad because it is otherwise of good quality. Returned to Amazon.
Graham Bergey
Reviewed in Canada on September 1, 2018
Came very close to breaking it with pliers trying to make it stop dripping, unsure if it can ever be opened again
Recommended Products
