Shopping Cart

Your cart is empty.

Your cart is empty.

Dopro 4pcs USA(Imperial) LP Guitar Speed Dial Knobs 24 Fine Splines Control Knobs for USA Les Paul/CTS Pots Black

Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

1.:Pack Of 2


2.Color:Black


About this item

  • Knobs only fit guitars or basses with USA 24 fine splines split shaft pots, they DO NOT fit metric 18 coarse splines split shaft pots with 5.8mm diameter.
  • In order to get correct knobs for your pots, please remove the current knobs from your guitar, count the splines on your pots, if they are 10 on each side, your pots will need 24 fine spines knobs; if they are 8 one each side, your pots will need 18 Coarse splines knobs; Please see our photos for reference
  • Push on fit knobs
  • Well made quality guitar knobs, not cheap or inferior knobs in the market
  • Please be sure to verify the splines on your pots before ordering



4.4 out of 5 stars Best Sellers Rank
  • #2,242 in Musical Instruments (See Top 100 in Musical Instruments)
  • #3 in Electric Guitar Knobs
Date First Available March 28, 2020 Color Name Black-1 Size Pack of 4

USA/Imperial Spec LP Guitar Speed Dial Knobs 24 Fine Spline Control Knobs for Gibson Les Pauls or CTS Pots


Rafael
Reviewed in Brazil on February 7, 2025
Muito bem acabados, bonitos de se ver, e se encaixam perfeitamente nos potenciômetros CTS. Recomendo bastante, valem muito a pena. Deus os abençoe!
Kindle Customer
Reviewed in the United States on February 24, 2025
I went to remove it and it was so stuck that when it came loose it took the pole with it. It was a 24 spine pot too which it claims to be compatible with. It's a Bad product. It would have looked nice if it wasn't fundamentally flawed.
dweegy
Reviewed in the United States on February 20, 2025
Fit PRS S2 pots snug and secure. I understand that S2 electronics are borrowed from the SE line, so would imagine work with many SE guitars.This shape is much easier to grip vs the “top hat” OEM style which was always frustrating and slippery using the push/pull tone knob- this should fix that.This knob material feels to match the PRS knobs being a hard plastic (perhaps the part that has splines is aluminum but didn’t pay attention). These are not, nor claim to be, a soft material. However, these are the least expensive replacement knobs on amazon and I feel confident they will survive many volume and tone adjustments without concern. No complaints for the $7 investment.
Darren C.
Reviewed in Canada on February 12, 2025
Fit nice at first but then 2 of 4 fell off during Jam. They are Brittle inside and splines broken inside. And confirmed…this was for correct spline and pots. Spend more and get Something else.
Don Bynum
Reviewed in the United States on February 11, 2025
fits good
Trevor P.
Reviewed in the United States on January 20, 2025
Looks good and great quality for a decent price. Snug push fit but made for 24 spline shaft. Not sure if these are actually aluminum as described but probably at least lucite on the top so you can see the numbers.Updated my MIA Jazz base with new Bartolini noiseless pickups, CTS 250K audio taper pots, and a 47mfd capacitor to eliminate the original grease bucket wiring.Very happy with results but if you have CTS splined pots you will need knobs like these that fit 24 fine splined shafts and not knobs that are made for18 spline course splined shafts.
Customer
Reviewed in Canada on July 5, 2024
These fit my USA Les Paul standard. I like these better than the top hat knobs. I use my volume knobs all the time and these are easier to find and turn in the middle of a song...
Brian in AZ
Reviewed in the United States on May 11, 2024
These speed knobs are exactly what you would expect. Clear lettering, the splined holes are concentric with the rest of the knob. Everything about them is decent quality. However, if you don't know what the, "splines per inch" measurement is on the pots you wish to put them on, they may not fit. That's not the fault of the product.I have a little trick I use if they don't quite fit; heat up the shaft of the pot with a cigarette lighter or a soldering iron, then push them onto the shaft. They'll form to the shaft and you're good to go. Another method is to take a drill bit. slightly larger than the hole in the knobs, and by hand, twist the drill in there a few turns to enlarge it, then put the knobs on.
Henry H.
Reviewed in the United Kingdom on March 29, 2024
Nothing to dislike they fit my guitar perfectly …
Mark Hinds
Reviewed in the United States on November 18, 2024
Great design. Looks like an older part
Adam F
Reviewed in the United Kingdom on November 15, 2024
These fit CTS pots perfectly and are excellent quality, as good as Gibson original.
Customer
Reviewed in the United States on November 10, 2024
What can I say the round they have numbers and they fit on the guitar. I do everything a knob should do
codymac5
Reviewed in the United States on October 13, 2024
I got the black with white letters fine spline to go on my CTS pots. I needed to replace some on a modified Epiphone guitar. Pay attention to if you need fine or corse spline knobs, I believe people make this mistake and blame the knobs. Also you have recessed and that’s what these are so they will sit lower to the body. For fun I compared them to my Gibson knobs and I noticed these knobs are about 1mm thiner as in height and the lettering is not as large or white but they are fine. I have had other black speed knobs and on many you will notice on the bottom edge you can see through to clear plastic. On these I took a very close look and noticed they took the time to paint that bottom edge lip. I think that’s a nice touch for such an inexpensive knob. Side note don’t spread or smash your pots with a pair of pliers if it’s to loose or tight your better off replacing the pots. Overall I’d recommend these as an inexpensive alternative to the name brand if you don’t have the money or the guitar is inexpensive. The look and function as they should.