Your cart is empty.
Your cart is empty.Eight (8) channel single wire multi-switch (swm). allows any transponder from any satellite input to be independently selected and distributed via one of eight designated swm output frequency channels. General information - product model - swm8; product name - swm8 single wire satellite distributer; frequency range - 950 mhz to 2150 mhz; interfaces/ports - ports - 8 x antenna out
Joaquin Alvarado
Reviewed in the United States on July 16, 2016
I did a lot of reading before I was able to figure out how all the parts went together. If you are RVing, you'll need a Power Inserter to make this work. The power inserter actually sends power back into this unit and is plugged into one of the cables and from the power inserter you plug the cable to your receiver. It doesn't matter which receiver you plug it into as long as you match that cable to the power inlet on the splitter also. I know... confusing... do your homework. Look at all my reviews. The splitter is a Direct Tv Msplit4R1-03 that I used. If I had done more reading, I would have purchased a Two way splitter cuz that's all I needed for my RV. This four way was recommended and I just followed the recommendation out of ignorance.
A. Mefford
Reviewed in the United States on February 24, 2016
This worked perfectly to upgrade my old style system to a SWM capable installation and I am now supporting Genie with remote Internet connected boxes throughout my home.I combined it with this splitter:https://smile.amazon.com/gp/product/B0045DVIP4/ref=cm_cr_ryp_prd_ttl_sol_67The splitter was probably overkill, as this is limited to 8 active tuners. Tuners is not equal to the number of cable runs required. With SWM each cable run can support multiple tuners. In the case of a Genie, a single cable run supports 5 tuners. This leaves only 3 open tuners from the 8. My old install had 3 HR21-HR24 dual tuner HDDVRs. I had to decommission two of the old tuners to enable the Genie to operate properly. With SWM enabled only a single cable is required to use both tuners on an HR24, and B-Band converters need to be removed.Don't listen to DirecTV when they tell you this cannot be done as a self install. There is some work involved but it is very achievable.
robert cookus
Reviewed in the United States on May 26, 2015
would not work on my system according to the direct tv tech on 5/23/15 hoping to be able to return this item
Nevada Geezer
Reviewed in the United States on February 18, 2015
Arrived quickly and worked exactly as advertised.My only complaint is that it did not come with any sort of documentation.Fortunately I found everything needed for installation on http://www.swm8.comI see this sort of problem all the time where the product is fine but is supplied either poor or zero documentation. Don't they ever learn?Took about an hour to install and configure the receivers.
M. Gentry
Reviewed in the United States on December 3, 2015
Very nice device. Needed this to allow us of our DirecTV H25 receiver in our motor home which only has the setup for the older style DirectTV equipment.Basically this device converts your setup to SWM technology so if you have the H25, HR25 or the even newer Genie devices and an older style Satellite dish you'll be in business. You still will Not receive HD programming but your dish will allow you to use the newer receivers.Easy hookup as well, Just do a search for this device and you should find a PDF with everything you need.You Will need a power inserter for this particular device, the one on your current SWM setup is different. If you don't get the correct power inserter then this device is useless.
RML3
Reviewed in the United States on October 16, 2014
this still didn't solve my problems
DesignNut
Reviewed in the United States on January 2, 2013
For those you are DIY individuals who happens to be DirecTV subscriber, this item is essential to convert the legacy system to SWM system. SWM allows you to set-up Whole Home DVR system and use the existing single RG6 cable to each room in your house.This box has the needed mechanism to provide signals to eight tuners. As the signals come in to the TV signal distrbution box, this SWM is needed to distribute the amplified signals from this SWM box to each tuner in the receiver.This product is great and also was sent promptly by the seller.Pro: works as promised.Con: none.Recommended to buyers who understands the way SWM signal system works.
Randy Underwood
Reviewed in the United States on December 11, 2012
Had an lnb that only allowed me 4 receivers (or 1 dvr and 2 receivers) ordered this item for 50 bucks and it came with the power inverter (so don't order one by itself) and I installed it along with Directv 8-Way Wide Band Splitter for SWM LNB adn now i can run up to 8 receivers if I want to and i only spent $75 total on the project. Would have cost me at least $200 with a Directv installer!! I'd highly recommend it!!
Recommended Products
$49.99
$ 21 .99 $21.99