Your cart is empty.
Your cart is empty.Chuck
Reviewed in the United States on February 26, 2025
Works as it should !!
Terry Marsden
Reviewed in Canada on January 16, 2025
It did what it was designed to do
Chris Shotkoski
Reviewed in the United States on July 30, 2023
Use it once and then it quit working
James Z
Reviewed in the United States on July 4, 2022
Things too small for reflective tape used by non- contact tachs ? This is for you. Storage bag and instructions included. No batteries.
J. Bruha
Reviewed in the United States on July 16, 2022
This is a neat little digital tachometer that works by holding against a rotating shaft. It comes with different tips, to best keep it centered on shafts with different end profiles. I checked against a known accurate tach, and it seems accurate. It is very easy to use, the controls are simple and intuitive. I would give it 5 stars if it came with an extended shaft or extended tip. As it is, it isn't quite long enough to reach a couple of my shielded shafts that I want to monitor. Had to try to find an extended tip separately. In my case the shaft is recessed a couple inches from the inspection hole in the housing. For any kind of shaft with an exposed end, it would be great.
james laberge
Reviewed in Canada on May 19, 2022
good
Koubie(Stan Ryhorchuk)
Reviewed in Canada on March 24, 2022
I ordered the wrong item so therefore this is o good to me
Oana Mogovan
Reviewed in the United States on January 6, 2021
I find it a bit odd that there is no off button, but it automatically turns off after 30seconds or so.I'm using it to measure the drum speed on my coffee roaster. My only complaint (which is my fault because of my application) is that these rubber tips melt easily (my drum is 400F+). It would be perfect if they were made of high temp rubber, but i'll look for a solution on my end.
MICHAEL KELLY
Reviewed in the United States on April 11, 2021
EASY TO HOLD ONTO AND TOUCH THE MOVING SHAFT
Recommended Products