Your cart is empty.
Your cart is empty.Design Engineering Fire Sleeve & Tape Kits are constructed from a high temperature resistant braided glass material, woven into a sleeve and heavily coated with 100% silicone rubber. Fire Sleeve provides the ultimate in heat insulation and protection from direct heat up to 500 degrees Fahrenheit. Each kit includes a 16-inch length of black Fire Tape to finish off ends of Fire Sleeve or when joining two Fire Sleeves together to present a clean and professional look.
Gilbert Villanueva
Reviewed in the United States on July 24, 2024
I used this to wrap around my rubber break line o 63 Fairlane. The over axle bend from exhaust was a little to close for my comfort. I cut a 5" piece in half and zip tied around line. Outer material is rubber, good thickness. About month of use and going good.
Edward Jones
Reviewed in the United States on July 11, 2024
This is perfect for protecting the air lines to my wastegate from melting. No more over boosting :)
Rock Crawler
Reviewed in the United States on June 13, 2024
I am thoroughly pleased with this heat shielding that I used on my classic car fuel line.Pros:High quality materialsWorks as describedEasy to work withLooks goodCons:Needs to be available in bigger rolls
Richard
Reviewed in the United States on May 8, 2024
Perfect for keeping my fuel lines and oil line away from the heat. Great blocker, I have no complaints
Alex
Reviewed in the United States on November 26, 2023
Used this on 20ft of fuel line and hydraulic fluid lines to protect it
Pimpindaily
Reviewed in the United States on January 12, 2023
DEI 5/8” ID protective sleeve fits snug over 8x13mm hose or 5/16 fuel hose for a diy project on my bmw. The section of hose I was replacing had rotten out and the dealer/parts store were asking too much for that small section of hose that came insulated so therefore i searched up my next best option for heat protecting my own off the shelf fuel line. And it turned out great. Just be aware of the fiber glass fibers inside this shielding which can becomes messy rather annoyingly quickly if it’s your first time handling fiberglass. Be prepared, have gloves when handling this stuff. They give you a rubber like tape to seal off the ends from fraying also to prevent the loose fibers from creating any mess I decided to use marine heat shrink tubing that I had laying around and I must say I’m pleased with the outcome and will be soon doing the remaining part lines covering it with this stuff :)
Customer
Reviewed in the United States on July 20, 2018
HARD TO CUT, WITHOUT GETTING LITTLE BITS OF FIBERGLASS SPLINTERING OUT WHEN CUT. BUT IT DID THE JOB .
Charlie
Reviewed in the United States on November 11, 2016
It's expensive stuff, but well worth it. I use this on my heater hoses, my clutch line, and my A/C lines as they all come just inches from my headers on my LS2 swapped car. No melting, no weird smells. Very happy with them. The friction tape they give you is meant to wrap the ends of sleeve. I do find that over time the friction tape starts to unwind some. If I did it over again (or ever have the hoses off again)I'd still use the friction tape, but I'd try to find some big heat shrink tube. That way you can slide the tube over the friction tape and shrink it down. This would keep it from unwinding and give it a cleaner look.
Recommended Products
$79.99
$ 35 .99 $35.99