Your cart is empty.
Your cart is empty.Product Description
Combining country flavor with graceful design, Allure(R) boasts an unmistakable visual appeal that complements any kitchen. Look closely and you can see hints of the watering can inspiration behind the design.
From the Manufacturer
Combining country flavor with graceful design, Allora(R) boasts an unmistakable visual appeal that complements any kitchen. Look closely and you can see hints of the watering can inspiration behind the design.
RLO
Reviewed in the United States on March 8, 2025
Looked slightly different than the original (12 year-old Delta), but the fitting was the same size and it attached and worked perfectly.
Myohmy
Reviewed in the United States on March 5, 2025
Gonna give this 5 stars even though I had to cut straw a bit to fit my Kohler pump as my liquid bottle is not quite as long as what came with the pump replacement. I had a bit of a time jamming this into the pump handle but eventually got it in and after pulling down on it, insured that it would not fall out and into the bottle, which would suck, as I have a disposal under my sink which makes it very difficult to get to my bottle. I think I should be fine, though. Now pumps soap as it did when the dispenser did when it was new. I would recommend.
Migeli
Reviewed in the United States on March 1, 2025
The only way to make it fit is to drill the tube to 3/64 than it works fine.
Lwos
Reviewed in the United States on February 6, 2025
In 2015 a Delta “Ashton” 19922- DST faucet with the soap dispenser ( now discontinued ) in a brushed stainless steel. The dispenser isn’t metal though. I saved the instructions and parts list. Over the years, I noticed the pumping action diminishing to where it quit. Actually, the pump wouldn’t recover to upright from pushing down. I tried WD 40 and it worked, for a half a day, then it would fail. I research part # RP47888 in the parts list of my faucet. Amazon popped up showing I could purchase the pump. I comes with a soap holder, but I didn’t need that. I saw the EXCELLENT PHOTOS others posted and compared my broken pump unit to the photos and it was a perfect match, tip to tail. . It arrived. I swapped out the old for the new… and it works PERFECTLY. I’m back to pumping. I just went back purchased another. I want a back up as I know this will fail again. I’m not sure its failure was due to the viscosity of soap, but it may be. I use dawn, which is fairly thick and if it sits ( which it will inside the pump chamber) it gets stiffer and sticky. I only pump my dispenser maybe 1x a day… 5x a week. Maybe a thinner soap will be easier on the pump. I’m going to “FLUSH” the pump at least 1x per month with hot water so maybe the residue won’t build up inside the chamber. Hope it works for you. I’m a 75 yr old gal so if I can fix mine, you can too. Pay close attention to the TIP that fits into the plunger and diameter of the pump. Then push the pump tip ( don’t twist) into the plunger. I turned my plunger upside down with the dispenser’s nozzle over the sink (so as not to damage or snap off) then pushed the pump into the bottom all the way down until it seated. Works smooth as glass. I’ve attached a copy of the parts listing for this unit.
E.C. H.
Reviewed in the United States on February 4, 2025
Our house is 13 years old. The soap pump in the kitchen went out. After ordering a Delta pump, that didn’t work, I realized this pump had ridges. Also looking at the reviews people commented it was to replace the pump in an older soap dispenser. This one works great.
krisesch
Reviewed in the United States on February 26, 2025
This states it is the correct replacement for my Delta soap dispenser but it isn’t. The ID of the opening is approximately 4mm. The OEM product is approximately 6mm. Back to the drawing board, I guess.
Delta Klevi
Reviewed in the United States on January 27, 2025
So far, so good.. Fairly easy to screw the spout onto tube. One press and done..
Brian W Dalton
Reviewed in the United States on June 10, 2024
The quality seems fine, but this pump is the wrong part for my Delta Soap Dispenser, RP37039RB (circa 2012 - now discontinued). It does not fit. Researching the right part with the correct fit is difficult for this particular item for some reason. My fault for making the wrong choice, but this is just to alert others to be extra certain that they choose the correct replacement part by careful research.In my photo, the old pump from my dispenser is on the left and the pump on the right is the one I ordered in error. They are not compatible.
Tax Dr.
Reviewed in Canada on May 10, 2024
Exactly what I needed and works A-1
w. brearley
Reviewed in Canada on April 4, 2022
Quick fix for dispenser. was as advertised, and now have working sink/soap dispenser.
Cindy
Reviewed in Canada on May 15, 2021
It wss exactly what i ordered.
RICHARD LAPOINTE
Reviewed in Canada on October 21, 2019
Mauvais modèle
gordonb
Reviewed in Canada on March 3, 2017
The 3rd one to arrive had the pump in it (missing from the first 2 delivered). Pump works exactly as the old one,Very good although it took over 3 months to get the missing pump portion.
Recommended Products
