Your cart is empty.
Your cart is empty.Product Description
DC Multifunction Battery Monitor Meter
The PZEM-015 DC multifunction battery monitor meter is mainly used to test all kinds of battery’s voltage, discharge current, discharge power, discharge impedance, internal resistance, capacity, SOC, energy,running time, and display the measurement data through LCD screen.
Specification
- Power consumption
- Normal working state: 0.03-1.2 W
- Sleeping state: 0.5mW-0.5W
- The power consumption is related to the test voltage valve,the higher the voltage,the greater the power consumption.
- Working temperature-20’C ~ +60’C.
Display interface is large-screen LCD, it can display nine parameters at the same time
- Voltage: Measuring range: 0-200V；Minimum Resolution: 0.01V (when the test voltage is ＜8V, please use the independent power supply mode)
- Current: Measuring range: 0-300A. The starting test current: 20mA
- Power: Measuring range: 0-60000W, Starting measure power: 0.2W
- Impedance: Measuring range: 0-1000Ω
- SOC Percentage Display:Displays the percentage of power remaining
- Capacity: Measuring range: 0-1000AH.
- SOC: Dump energy is display via the battery symbol, totally 10 grids, every grid present 10% energy.
- Energy：Measuring range: 0～9999kWh.Over the test range will become zero.Note:1Wh=0.001kWh=0.001 Kilowatt
- Running time:Measuring range: 0 ~ 999 hour (without load the time will not accumulate)
No Screws Design
- Push-on terminal,no need screws to connect
LCD Dispaly
- Large-screen
- LCD with a full sight 180°-view
- The blue backlight can be turened on/off manually
Widly Application
- DC Multifunction Battery Monitor Meter widly used for solar penel,wind generator,industrial assebly line,automobile/RV,etc.
Brad
Reviewed in the United States on February 23, 2025
works with 24v house solar power
James spoon
Reviewed in the United States on July 18, 2024
I just received the product.. I didn't realize it was so small, but it's supposed to be powerful. I will seeThey say dynamite comes in small packages.. I'm looking forward to giving my review
Customer
Reviewed in Canada on March 10, 2024
En remplacement de l autre ,shunt sans base de plastique, écran installé , mais pas le shunt encore j y travaille .
AndMe
Reviewed in Canada on February 3, 2024
Works fine so far
Steve Billmeier
Reviewed in the United States on February 20, 2024
Hooked up easy. It displayed right away. Great readout.
Eivind Hagen
Reviewed in the United States on December 22, 2024
This is more of a diagnostic tool, not a shunt that will track current in and out of a battery (which is what I wanted). I have another shunt that tracks both directions and will accurately show current state of charge (SoC). Sadly, this device doesn't do this.
clark v.
Reviewed in the United States on November 2, 2024
can be a little difficult to set up but other than that its accurate.
Kodjo
Reviewed in the United States on January 22, 2024
Love the brightness and easy display on battery State of Charge (SOC) - no more guessing battery capacity.
Mark P.
Reviewed in the United States on December 28, 2023
Accurately displays more info than other more expensive systems. This is must for battery monitoring.
GB
Reviewed in Canada on October 26, 2023
Okay, typical Chinese stuff with complicated programming options that aren’t intuitive and instructions that are poorly translated. Once you figure it out tho, it works fine and does the job. Not as precise as a Victron smart shunt, but it’s close enough to confidently see what’s going on with your battery. Oh and it is 6 times cheaper than a Victron shunt, so if you just want to monitor a small 12V battery, it’ll do you good service.
Luc
Reviewed in Canada on October 11, 2023
Accuracy is questionable.The voltage reading does not match the reading from 4 other meters; it is lower.The current (amp) is also questionable. With the shunt disconnected from the battery, the meter show a current of 2A, that would actualy be recharging the battery. How is this possible if the shunt is disconnected from the battery???
nh19926
Reviewed in the United States on April 10, 2023
I decided to try one of these cheap meters.. big mistake. Waited a long time to get it, allegedly shipped from Los Angeles but not so. From China and a drop box used in Los Angeles, CA. 10A setup did not work, aH incorrect reading... and could not set it. I have used other similar meters but they were $60 to $80 and worked perfectly. All this garbage just delayed my project (again). Should have bought the other meter like before. Do not buy.
Allan Bowman
Reviewed in Canada on November 13, 2022
Product used on RV to monitor Lithium batteries. Easy to program limits, battery capacity, and other factors. Bright readable display. In my application only 4 wires to connect.
Recommended Products