Your cart is empty.
Your cart is empty.Pinion Yokes and Yoke Accessories from Yukon Gear and Axle for replacement and performance applications. Yukon yokes are engineered and quality tested to provide maximum durability and strength in street, racing and off-road environments.
TF
Reviewed in the United States on February 3, 2025
This does NOT fit a Dana 60 !!! Bolts are too small in diameter and length
billybop
Reviewed in the United States on June 30, 2024
Used this to replace old corroded U-joint strap on vehicle. Looked just like the OE set and fit perfectly, well package and ready to use out of the box.
Rob
Reviewed in the United States on November 20, 2024
Genuine spicer parts that seemed to be out of stock everywhere else!
RYAN LESSLEY
Reviewed in the United States on January 20, 2023
Does not fit a 2nd gen dana 70 for a dodge. The holes line up but the bolt do not work. Also there is about 1/32 of and inch gap of u-joint movement front to back.
Dan
Reviewed in the United States on April 25, 2023
It’s held up on my 7.3 turbo and they were the only company that had them
Simon
Reviewed in Canada on May 29, 2022
Front driveshaft 8mm bolts were stripped on my superduty at the differential. Replaced with this kit and I’m back in buisness.
Curtis Neumann
Reviewed in Canada on October 15, 2021
Yukon, can't go wrong with their stuff.Works as it should. It's U joint straps, not a whole lot to them to review haha.
Stitchwitch 1117
Reviewed in the United States on September 23, 2020
These parts fit and work as required.
Max Barrington
Reviewed in the United States on July 11, 2020
U-joint straps look strong but do not fit for my application
IBNFECPO
Reviewed in the United States on September 16, 2019
Fought for my 2006 Ford E450 motorhome with three drive shafts V10 engine an automatic transmission. Had driveshafts upgraded with all new universal joints and carrier bearings due to vibration between 40 in 55 miles per hour. Did the trick for me
Guillermo Tovar
Reviewed in Mexico on June 2, 2019
No se para que eje sea esta pieza, pero no es para un Dana 60. Lo probé en el eje delantero de mi camioneta y lo primero que noté fue que los agujeros no coincidían. Después de hacer nuevos agujeros en las placas, los tornillos eran de rosca diferente al yugo de fábrica. Al final, compré nuevo tornillos, sólo para comprobar que la cruceta) U-joint) se había salido del yugo por la falta de retenes en la placa. El material parece bueno, como en todos los productos Yukon, pero esta pieza no es para un Dana 60 delantero
Corey H
Reviewed in Canada on December 5, 2019
Work perfect. So far I've used them on 2 different 1410 joints
Bubba
Reviewed in Canada on December 24, 2019
great fit
Recommended Products
$130.58
$ 64 .99 $64.99
$172.54
$ 71 .99 $71.99
$111.95
$ 54 .99 $54.99